Fax +1 305 430 9692
Step 6: Insert the hose insert into the barrel (for vacuuming function)
or in the "blower" hole (1) located in the main body (for blower
function). Gently rotate to the right to lock the hose in place and
make sure it fits tightly (Fig. 6).
Step 7: Insert the adjustable tube into the hook and set the tube in
place (Fig. 7). Fasten with the screw.
Step 8: Insert curved tube of the hose into the adjustable tube (Fig.
8). Make sure the connection is tight.
Step 9: Insert the end of the extension tube into the floor brush (Fig.
9). Make sure the brush is tightly attached to the tube.
USING YOUR VACUUM CLEANER
Assemble the vacuum cleaner before use.
ADD WATER TO THE BARREL BEFORE USE. Vacuuming without
water can damage the motor.
DO NOT operate the vacuum when water level is below the
"Working Level" line on the water tank.
Copies of the I/B. Please reproduce them without any changes
except under special instruction from Team International USA.
The pages must be reproduced and folded in order to obtain
a booklet A5 (+/- 148.5 mm width x 210 mm height). When
folding, make sure you keep the good numbering when you
turn the pages of the I/B. Don't change the page numbering.
Keep the language integrity.
On/Off Switch
Fig. 10
6
Assembly page 6/40
Print only what is inside the frame.
WFVC 43331 - 120501