Kalorik WFVC 43331 Manual De Instrucciones página 7

Fax +1 305 430 9692

Use: The water filtration vacuum cleaner can be used on dry and
wet surfaces. To use as a wet pick-up vacuum, operate the unit on
the wet surface as you would for a dry surface.
WARNING: DO NOT overfill the water tank. The unit will stop working if
the tank is full. If full, turn off and unplug the unit. Then empty the
tank and clean. Refill with clean water at the "Working Level", then
plug unit back in and continue working. DO NOT tip over.
On/Off Switch: Turn the unit on or off by pressing the power switch
located on top of the main body (Fig. 10).
Air Flow Control: Adjust the suction level by moving the pusher up or
down (Fig. 11).
Floor Brush: The floor brush can be used for hard floors and carpets.
Use the switch located on top of the brush to adjust the brush to the
type of floor you are cleaning. Lower the brush for bare floors, raise it
for carpets (Fig. 12).
Adjustable Tube: Adjust the tube to the desired length by pushing
the control switch. Release the button to lock (Fig. 13).
Motor thermostat: The vacuum cleaner is equipped with a motor
protective thermostat. If the unit overheats, the thermal protector will
shut off the unit. Should this occur, turn off the vacuum cleaner and
unplug from the wall outlet. Allow the unit the cool before using
again.
Copies of the I/B. Please reproduce them without any changes
except under special instruction from Team International USA.
The pages must be reproduced and folded in order to obtain
a booklet A5 (+/- 148.5 mm width x 210 mm height). When
folding, make sure you keep the good numbering when you
turn the pages of the I/B. Don't change the page numbering.
Keep the language integrity.
7
Assembly page 7/40
Print only what is inside the frame.
Fig. 13
WFVC 43331 - 120501