Braun Oral-B TRIUMPH Manual De Usuario página 7

In the first days of using the toothbrush, your
gums may bleed slightly. In general, bleeding
should stop after a few days. Should it persist
after two weeks, please consult your dentist or
hygienist. If you have sensitive teeth and gums,
Oral-B recommends using the «sensitive» mode.
Brush heads
The Oral-B FlossAction (a) brush head is
recommended for everyday deep cleaning. For
occasional or everyday polishing, use the Oral-B
ProBright (j) brush head (not with all models).
Please note: children under 12 should not use
the Oral-B ProBright brush head.
a a
Both brush heads contain a «smart chip» to
communicate with the electronics inside the
toothbrush handle. Therefore, your toothbrush
automatically switches to the appropriate
brushing mode for the attached brush head.
Nevertheless, you can select other brushing
modes to customize your routine.
Do not use these brush heads with braces. We
recommend using the Oral-B Ortho brush head,
which is specifically designed to clean around
braces and wires.
SmartGuide display unit
Icons
«Clean» mode
«Sensitive» mode
«Massage» mode
«Polish» mode (not with all models)
Too much pressure is applied.
Reduce the brushing force.
j j
«Quadrant circle» – currently you
are brushing in the first 30-second
interval. Move to the next quadrant
of your mouth, when the second
segment starts flashing.
Dentist recommended 2-minute
brushing time has been reached.
«Pre-notice» that your brush head
*
needs to be replaced soon. You can
use it for another 10 days (twice a
day, 2 minutes) before the recom-
mended replacement time has been
reached.
Your brush head has surpassed the
*
dentist recommended usage time of
3 months (twice a day, 2 minutes).
Replace it with a new one.
The rechargeable battery of the
handle is low. Charge the
toothbrush handle.
Batteries of the SmartGuide display
unit are low. Change batteries of the
SmartGuide display unit.
* the «brush head replacement» and «pre-notice
brush head replacement» features only work
when using brush heads enabled with Smart
Technology (Oral-B FlossAction and Oral-B
ProBright)
Wall mount
If you prefer to mount the SmartGuide display
unit on a wall, mirror or other surface, use the
adhesive tape (m) to fix the wall mount. Before
doing so, make sure the chosen surface is clean
and dry (remove grease and dust first).
Position the wall mount so that the Oral-B logo
is readable. Then press the wall mount evenly
and firmly to the wall. Wait 24h before sliding
the SmartGuide display unit into the fixed wall
mount.
Please note: the adhesive tape will not work on
dirt-repellent surfaces.
7