Silver Eagle SE130 Manual Del Usuario página 2

www.matcotools.com
1) LUBRICATION:
Before connection of the hose, apply 4 to 5 drops of a good
quality air tool oil at the air inlet. After 3 to 4 hours of
operation, oiling may be necessary again.
2) TIGHTNESS OF PARTS:
Regularly check whether all connection parts are
fastened securely. Follow this procedure daily
before beginning work.
3) STORAGE:
Avoid storing the tool in a location subject to high humidity. If
the tool is left unused, the residual moisture inside the tool
can cause rust. Before storing and after operation, oil the tool
at the air inlet with a good quality air tool oil and run it for a
short period.
4) DISPOSAL:
Follow national legislation of waste disposal.
5) ORDERING SERVICE PART
For further operational and handling information or for
replacement of parts and components, contact the sales
agent from where you purchased the tool, or the service
division of our company, phone number 800-221-9705.
*When ordering parts and components, give each part
number, name, and quantities.
Replace the sand belt
Disengage and remove the sand belt from the idle pulley. Push
the idle pulley in the direction shown below. Replace a new belt.
Keep your hand away from idle pulley. Push tension bar indicated on
the drawing and the sand belt will be propped into the ready position.
Adjust Tracking
If the sand belt is not centered on the idle please follow direction to
center the belt. Adjust the hexagon socket head bolt on the idle
pulley bracket with accessory hexagon wrench key until centering
is correct. Turn the hexagon socket counter clockwise to move the
belt towards the bracket and vice versa.
Model:
SE130
WARNING
Product Type:
AIR BELT SANDER 3/8" x 13"
Page 2