Lighting Instructions; Maintenance - Costco 1500095 Manual Del Usuario

Warning: If these instructions are not followed exactly, a fire or
explosion may result causing property damage, personal injury
or loss of life.
1. Open the tank drawer and find the control panel on the left.
Make sure the control knob is in the "OFF" position. See
Figure 10. Open the tank valve all the way.
2. Push in the igniter button. You will hear a slight clicking
sound. With the igniter button pushed in, push and turn the
control knob to the "ON" position.
within a few seconds. Once the flame is lit, release the
igniter button and continue to hold the control knob in for 10
to 15 seconds. Release the control knob. The control knob
should pop back out and then the fire remains lit. Note: If the
fire does not light, turn the knob to the "OFF" position and
wait five (5) minutes before trying again.
3. To turn down the flame, push the control knob in slightly and
turn to Medium (medium flame), or Low (small flame).
4. To shut down the fire pit, turn the control knob to the "OFF"
position and turn off the tank valve.
The flames should look like those in Figure 11. To clean the burner, use a soft brush after the
burner has cooled completely. Never use a vacuum cleaner on the burner. It is
recommended to store the firepit indoors during winter if it will be subjected to freezing
temperatures. The LP cylinder must be disconnected and removed from the appliance
before the appliance can be stored indoors.
Jun-01-2017

LIGHTING INSTRUCTIONS

The fire should light

MAINTENANCE

Figure 11
10
Figure 10