Exterior Maintenance; Service; Operational Problems - Troubleshooting; Optional Equipment - Jotul I 150 FL Instrucciones Para Instalación Y Utilización

6.6 Exterior maintenance

Painted products may change colour after several years usage.
The surface should be cleaned and brushed free of any loose
particles before new paint is applied.
Enamelled products must only be cleaned with a clean, dry cloth.
Do not use water and soap. Any stains can be removed with
cleaning liquids.

7.0 Service

Warning! Any unauthorised change to the product is illegal!
Only use original spare parts!
7.1 Changing the burn plates, base plate
and baffle plate (fig. 6-7)
• First remove the ash retainer (7 A).
• The baffleplate (6A), which is resting on the burn plates, has
to be edged down and lifted out.
• Lift the base plate (7B) up and out
• Remove the burning plates (7C).
For re installation follow the same procedure in the opposite
sequence.
8.0 Reasons for operational
problems - troubleshooting
Poor draught
• Check the length of the chimney so that it covers the
requirements stipulated in national laws and regulations.
See also «2.0 Technical data» and «4.5 Chimney» for
information.
• Ensure that the minimum cross-section of the chimney is in
accordance with «2.0 Technical data»
• Make sure that there is not anything preventing the flue
gasses from escaping: Branches, trees, etc.
The fire extinguishes after a while
• Make sure that the wood is sufficiently dry
• Find out whether there is negative pressure in the house, close
mechanical fans and open a window close to the stove.
• Check that the air vent is open.
• Check that the flue outlet is not clogged by soot.
If an unusual amount of soot accumulates on
the glass
Some soot will always stick to the glass, but the quantity depends
on:
• Humidity of the wood
• The local draught conditions
• Regulating the air vent.
Most of the soot will normally burn off when the air vent is
opened all the way and a fire is burning briskly in the fireplace.
See also «6.1 Cleaning the glass - good advice»

9.0 Optional equipment

9.1 Ash solution - Cat. no.: 350718
The kit consists of :
New rear bottom plate-Ash grate-Ash pan-One bag of screws.
Assembly instructions are included with the product
english
1