Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting:
Problem: the grease gun is normally operated, but there is no grease squeezed out.
Reason: the grease gun has air, which causes empty injection phenomenon. Therefore, the grease cannot be squeezed out.
Solution:
1）Pull the driven handle to proper position at tail of the gun tube. Press the exhaust vent of the gun coupler by one hand,
press the locking sheet at tail of the gun tube by the other hand, and push the iron core handle into the gun body.
2）Pull the driven handle to proper position at tail of the gun tube. Loosen the gun coupler and gun tube. Press the locking
sheet at tail of the gun tube and push the iron core handle into the gun body.
3）Try to operate the grease gun several times. If no grease is squeezed out, repeat above steps 2 to 3 times until the
grease is normally squeezed out.
4）Tightly lock the gun coupler and gun tube.
5）Gently press the exhaust button until the grease is squeezed out.
#This phenomenon is more common during injection of the bulk grease.
Problem: there is grease leakage phenomenon at fitting locking position of outlet of grease gun.
Reason: the fittings aren't tightened properly.
Solution:
1 ）The thread of outlet of the grease gun is oblique thread which is the excellent anti-leakage design. If the thread enters
deeper, the anti-leakage function will be better.
2）Use relevant tool to tighten the fittings. Don't tighten only by hand. Only in this way, its excellent anti-leakage function
can be fully realized.
8
97204
Bulk grease barrel
中文
EN
DE RU KO PT
JA
ES
Publicidad
