IMPORTANT SAFEGUARDS
Read all instructions before using. Important information is highlighted by these
terms:
WARNING–Important safety information for hazards that might cause serious injury.
CAUTION– Information for preventing damage to the product.
NOTE–
Information to which you should pay special attention.
READ ALL INSTRUCTIONS BEFORE USING
Please follow these instructions carefully whether commode is used bedside or over
the toilet. Commode's height is adjustable for use in an elevated position. Back of
commode is removable for use over the toilet.
Please read carefully before use. Failure to comply may result in severe
injury.
Do not exceed the 250 lb. maximum weight capacity of this safety frame.
Ensure all detent buttons are properly engaged in position prior to use.
FAILURE TO FOLLOW THESE INSTRUCTIONS MAY RESULT IN SERIOUS INJURIES.
SAVE THESE INSTRUCTIONS.
ASSEMBLY INSTRUCTIONS
Before beginning assembly, identify all parts. If you are
missing any parts, contact your retailer.
1. Remove existing toilet seat / lid assembly.
2. Place toilet safety frame bracket between toilet
fixture and toilet seat / lid assembly with rounded
part of bracket facing back of toilet (Figure 1).
3. Replace toilet seat / lid and reinsert mounting
bolts through bracket and toilet fixture. Replace
and tighten nuts.
4. Insert side frames into bracket. Depress detent
button and slide side frame into desired position
(Figure 2).
5. Adjust footpieces to desired height. Make sure both
footpieces are fully engaged and adjusted at equal
heights.
6. Make sure mounting hardware is tightened and all
detent buttons are fully engaged before use.
.
Figure 1
Figure 2
E n g l i s h