Marmitek PROGUARD800 Serie Modo De Empleo página 4

INSTALLATION
1. Register all wireless devices to the ProGuard800 control panel as explained in
the ProGuard800 installation manual.
2. On the control panel, define the detection devices that are intended to transmit
via the repeater as follows:
• From the Programming menu, select Devices, Zones [911].
• Select the zone you want to program (1-32).
• From the zone's sub-menu, select Repeater [#9].
• Select "Use Repeater".
Note: It is not necessary to define, at the control panel, the keypads and
keyfobs that are registered to the repeater.
3. Open the RP835's plastic housing. To do so, remove the two cover screws
and lift the front cover away from the base.
Antenna
Connector
Upper
Mounting
Hole
Transmitter
Receiver
Power Input
Terminals
AC Power
Protection Fuse
Lower
Mounting
Hole
Wiring
Hole
4. Connect the antenna provided to the antenna connector.
5. Connect the backup battery pack to the Battery connector.
6. Connect a 9VAC or 12VDC transformer to the Power Input terminal block
(polarity is not important).
7. All registration and test functions, described in the following sections, are
performed from the LCD Programming Keypad (PK836) shown in Figure 3.
3
Figure 2: RP835 (cover removed)
LED Indicator
Flash
Programming
Programming
Keypad (PK836)
Backup
Battery Pack
Battery Connector
Lower
Mounting
Hole
Tamper
Switch
© MARMITEK