Thulos TH-DL07 Manual De Instrucciones página 12

**** TO PUT THE 7 LITERS DEPOSIT.
To place the 7-liter tank in the dispenser, we follow the following steps:
1. Take the tank (5) and screw the filling and cutting valve (6).
2. Adjust the tank with the valve directly to the dispenser without adapters.
3. With the tank tightly adjusted, fill with water.
4. During filling, keep the tap pressed until water comes out to remove all the air inside.
WARNINGS FOR FILLING IN ANY CASE:
Whether it's for bottles, carafes or for a deposit, you should consider:
- While filling the tank for the first time, operate the taps during filling until water starts to
flow out, this way the internal air is eliminated.
- If the internal circuit is left with air, it may run the risk of leakage or water loss.
OPERATION.
1. Before plugging in electrical power, first assemble and fill with water.
2. Make sure there are no leaks or water leakage.
3. Plug in electrical power.
4. Turn on the rear switch dispenser on top.
5. With the dispenser on, the blue faucet will throw cold water and the red faucet
will throw water at room temperature.
6. It is advisable to turn off the dispenser during the night.
7. If it is not going to be used for a long time, turn off, unplug, clean and store.
8. Always disconnect the power before changing a bottle or carafe.
MAINTENANCE AND CLEANING.
- Before cleaning, always unplug the electric current.
- Always keep the space around the dispenser clean of dust and clear.
- To prevent and prevent the growth of mold, do not place the dispenser in places
exposed directly to sunlight and / or hot air currents.