Tetrafauna ReptoFilter Manual De Instrucciones

Instructions – Important Safeguards and Warranty
Decorative ReptoFilter
1
(1) Outflow tube with
elbow fitting
(1) Tubo de flujo de salida con
accesorio en codo
(1) Tubo de saída
com cotovelo
(1) Decorative
ReptoFilter ™
(1) ReptoFilter™
decorativo
(1) ReptoFilter™
decorativo
(2) ReptoFilter
cartridges
(2) Cartuchos de ReptoFilter TM
(1) 90 gph pump
(2) Refil de ReptoFilter TM
(1) Bomba de 90 gph
(1) Bomba de 340 l/h
Start by verifying all parts for assembly are included in the package.
2
Press outflow tube into pump
discharge opening.
5
Rinse cartridge filters under
cold tap water to remove any
carbon dust.
8
Place filter unit in corner of
tank, and fill until water level is
between minimum and maximum
lines (levels are indicated on
side of filter).
* Replace filter cartridges every two weeks or sooner for optimal performance.
Decorative ReptoFilter™
®
Made for
Copyright © 2006 Tetra Holding (US), Inc.
3001 Commerce St., Blacksburg VA 24060-6671, U.S.A.
1-800-526-0650
TM
3
Slide O-ring over elbow fitting,
keeping it approximately 1/4"
from end of elbow fitting opening.
6
Insert filter cartridges into slots
on either side of pump and
slide all the way down until
seated on bottom.*
9
Plug in filter...
Tetra ® , Tetrafauna
Decorative ReptoFilter
Patent number US 4783258 & 5053125
Made in China.
www.tetra-fish.com
(1) Lid
(1) Tapa
(1) Tampa
(1) O-ring
(1) Junta tórica
(1) O-ring
(1) Sample packet
of ReptoMin ®
(1) Paquete de muestra
de ReptoMin ®
(1) Amostra de Alimento
ReptoMin ®
4
Place assembled pump in bottom
of Decorative ReptoFilter. Slide
outflow tube with O-ring into
groove at top of front of filter.
Slide down until O-ring seats
at bottom of groove to form
a watertight seal. Rout pump
cord through small notch at
rear top of filter.
7
Place lid on filter.
10
...and create drip loop.
(For more information, see
Important Safety Instructions.)
™ , ReptoMin ® and
™ are trademarks.
IMPORTANT SAFETY
INSTRUCTIONS
READ AND FOLLOW ALL
SAFETY INSTRUCTIONS
DANGER
Special care should be taken to avoid possible electric shock, since
water is employed in the use of aquarium equipment. Do not attempt
any repairs by yourself; return the appliance to an authorized service
facility for service or discard the appliance.
WARNING
To guard against injury, observe basic safety precautions, including
the following:
1. If the appliance shows any sign of abnormal water leakage,
immediately unplug it from the power source.
2. Carefully examine the appliance after installation. Unplug the
appliance if there is water on parts not intended to get wet.
3. Do not operate any appliance if it has a damaged cord
or plug, or if it is malfunctioning, or if it has been dropped
or damaged in any manner.
4. To avoid getting the appliance plug or receptacle wet, position the
aquarium to the side of a wall-mounted outlet in order to prevent
water from dripping onto the plug or outlet. Arrange a "drip loop"
for each cord connecting an aquarium appliance to an outlet.
(See Illustration A.) The "drip loop" is
the part of the cord below the level
of the outlet (or if using an extension
cord, below the level of the connector)
that prevents water from traveling
along the cord and coming in
contact with the outlet.
5. If the plug or outlet should get wet,
don't unplug the cord. Disconnect
the fuse or circuit breaker
that supplies power to the appliance. Once the power has been
disconnected, unplug the cord and examine it for the presence
of water in the outlet.
6. Always unplug the appliance from an outlet when it is not in use.
Also unplug it before cleaning, and prior to disconnecting or
attaching parts. Never yank the cord to pull the plug from the
outlet. Grasp the plug and pull to disconnect.
7. Do not use an appliance for anything other than its intended use.
Do not use attachments that are not recommended or sold by
the manufacturer; they may cause an unsafe condition.
8. Do not install or store the appliance where it will be exposed to
the weather or to temperatures below freezing.
9. Make sure the appliance is securely installed before operating it.
10. If an extension cord is necessary, use a cord with a rating that
matches or exceeds the rating of the appliance. A cord rated for
fewer amperes or watts than the appliance rating may overheat.
Arrange the cord so that it will not trip anybody, and that it will
not be pulled in any way.
11. This appliance has a polarized plug (one blade is wider than the
other). As a safety feature, this plug will fit in a polarized outlet
only one way. If the plug does not fit fully into the outlet, reverse
the plug. If it still does not fit, contact a qualified electrician.
Never use with an extension cord unless the plug can be fully
inserted. Do not attempt to defeat this safety feature.
12. To avoid injury, do not touch moving parts.
13. Supervise children closely when they are near or using
the appliance.
SAVE THESE
INSTRUCTIONS
LIMITED TWO-YEAR WARRANTY
Tetra warrants this product against defects in material and
workmanship for a period of two years from the date of
original purchase.
If the product exhibits such a defect, Tetra will repair or
replace it without cost for parts or labor. The product must
be shipped postpaid to Tetra. Proof of purchase is required.
You are responsible for proper wrapping and the payment
of $5 for shipping.
This warranty does not cover damage caused by accident,
misuse, abuse or failure to follow product instructions.
All implied warranties, including any implied warranty of
merchantability or fitness for any purpose, are limited to
two years from date of original purchase.
In no event will Tetra be liable for consequential damages
resulting from the use of this product.
Some states do not allow the exclusion or limitation of incidental
or consequential damages, so the above limitation may not
apply to you. This warranty provides specific legal rights.
You may have other legal rights that vary from state to state.
Illustration A
Drip Loop