Weldy Iberian Energy HT1600 Manual Del Usuario página 8

Warning
DANGER! Danger when opening up the tool, as live components and
connections are exposed. Therefore, before opening it, unplug the tool
to ensure disconnection from the mains. Before putting into operation,
Deutsch
check power supply cord and connector as well as extension cable for
English
electrical and mechanical damage.
Français
Incorrect use of the Hot Air Tool (eg. overheating of the material) can
Español
present a fire and explosion hazard, especially near combus t ible
Português
materials and explosive gases.
Italiano
Do not touch the heating element housing and air nozzle when
Nederland
they are hot as they can cause burns. Let the tool cool down. Do
Dansk
not point the hot air flow in the direction of people or animals.
Svenska
Norsk WARNING: Danger of intoxication! When working with plastics,
Suomi varnish or similar materials, gases develop that can be aggressive
or toxic. Avoid breathing in vapours, even when they appear to be
Eλληνικά
Türkçe harmless. Always provide for good ventilation of the work area or
wear a respirator.
Polski
Magyar
Attention
Česky
The voltage rating stated on the tool must correspond to the mains
Slovensky
voltage.
Românã
Slovensko
For personal protection on building sites we strongly recommend
Български
the tool be connected to a RCCB (Residual Current Circuit Breaker).
Eesti
The tool must be operated under supervision. Heat can ignite flam-
Lietuviu
mable materials which are not in view. The machine may only be used
Latviešu
by qualified specialists or under their supervision. Children are not
Русский
authorized to use this machine.
日本語
中文
Protect tool from damp and wet.
‫ﻋﺮﺑﻲ‬
Repairs should only be carried out by authorized service points.
ภาษาไทย
Restricted to use with original Weldy accessories and spare parts.
8
Original Operating Manual
Warranty
• For this tool, the guarantee or warranty rights granted by the relevant distri-
butor/seller shall apply. In case of guarantee or warranty claims any manu-
facturing or workmanship defects will either be repaired or replaced by the
distributor at its discretion. Warranty or guarantee rights have to be verified by
an invoice or a delivery document. Heating elements shall be excluded from
warranty or guarantee.
• Additional guarantee or warranty claims shall be excluded, subject to mandato-
ry provisions of law.
• Warranty or guarantee shall not apply to defects caused by normal wear and
tear, overload or improper handling.
• Warranty or guarantee claims will be rejected for tools that have been altered
or changed by the purchaser.
Conformity
Weldy AG, Galileo-Strasse 10, 6056 Kaegiswil/Switzerland, confirms that
this product, in the version as brought into circulation through us, fulfils the
requirements of the following EC directives.
Directives:
Harmonized Standards: EN 12100, EN 55014-1, EN 55014-2, EN 61000-6-2,
Kaegiswil, 20.04.2015
Bruno von Wyl, CTO
Disposal
Power tools, accessories and packaging should be sorted for
environmental-friendly recycling. Only for EC countries: Do not dispose
of power tools into household waste! According to the European Directive
2002/96/EC on waste electrical and electronic equipment and its incorporation into
national law, power tools that are no longer suitable for use must be separately
collected and sent for recovery in an environmental-friendly manner.
2006/42, 2004/108, 2006/95, 2011/65
EN 61000-3-2, EN 61000-3-3, EN 62233,
EN 60335-2-45, EN 50581
Peter Kathriner, GM