Fisher-Price 79151 Manual Del Usuario página 4

Installation and Use
Door Lock
Indicator
Door
Hook
To close gate door:
• Grasp the handle on the gate door.
• Lift the gate door and push it closed so the door hook
latches over the top edge of the gate.
• Lower the gate door.
Gate door is in
threshold groove.
CORRECT
• Make sure the bottom of the gate door is in the
threshold groove.
Door lock indicator
does NOT show any red.
CORRECT
• Make sure the door lock indicator does NOT show
any red.
• If the door lock indicator shows any red, the gate
door has NOT been closed properly. Re-read Installation
and Use steps -
Handle
Gate door is NOT in
threshold groove.
INCORRECT
Door lock indicator
shows red.
INCORRECT
and close the gate door again.
To Remove
Threshold
• Pull the locking lever release
arrow while lifting the locking lever up
• Make sure the top of the triangle on the locking lever
aligns with the top of the triangle on the threshold.
• Slide the gate door and stationary panel together.
Maintenance
• The pads should be cleaned periodically using a mild
solution of soap and water. If the pad surfaces become
dirty, it may affect holding strength.
• To clean the gate panels, wash with a mild solution of
soap and water. Rinse with clean water to remove soap
residue and wipe dry.
If you have any questions about this product:
In Canada, call 1-800-567-7724, or write to: Mattel/Fisher-Price, 6155 Freemont
Blvd., Mississauga, Ontario L5R 3W2.
In Great Britain, telephone 01734 770488.
In Australia, call the Fisher-Price Australian Consumer Advisory Service toll-free at
1-800-800-812, or write to: Fisher-Price, Mattel Pty. Limited, 461 Plummer Street,
Port Melbourne, Victoria 3207.
4
B
A Triangles
Locking
Lever
Locking
Lever Release
A
in the direction of the
.
B