KitchenAid 5KSS1121 Manual De Instrucciones página 17

TROUBLESHOOTING
7. You hear CO escaping from
2
the Cylinder:
• There may be a pressure leak between
the CO Cylinder holder and the valve.
2
Screw the CO Cylinder tighter into
2
its fitting. Do not use tools.
8. If you experience poor carbonation:
• If you have not yet added flavour, try to
carbonate to a higher carbonation level.
• Check the CO Cylinder. You might
2
be out of CO .
2
• Make sure that you are carbonating
chilled water.
9. Water overflows from the carbonating
bottle during carbonation:
• Check that the carbonating bottle is filled
just to the fill line.
• Verify that the carbonating bottle is firmly
installed in the Snap-Lock. Check by gently
pulling the bottom of the bottle. If it feels
loose, then remove and reinsert.
10. If your sparkling drink is not
flavourful enough:
• Just add more flavour to taste.
• Do not re-carbonate after adding
the flavour.
11. Small pieces of ice appear in the
water during carbonation:
• This might happen when carbonating
very cold water. If this happens, shorten
the time of each press until the ice stops
appearing or it can affect the carbonation.
Any ice created will simply melt.
• Ice can form and restrict the flow of
CO into the bottle during repeated
2
heavy carbonation. Allow a few minutes
between carbonating several bottles to
maintain normal carbonation time.
WARNING: If you suspect your
Sparkling Beverage Maker is damaged, stop
using it immediately and call for service.
See "Warranty and service" section for
more information.
12. The gauge is not working:
You may need to replace the batteries as
shown in the "Care and cleaning'" section.
17