Important Safety Instructions - Armor All AA20TI Manual Del Operador

IMPORTANT SAFETY INSTRUCTIONS

WARNING!
READ AND UNDERSTAND ALL INSTRUCTIONS. Failure to follow all instructions listed
below may result in electric shock, fire and/or serious personal injury.
WARNING!
When using electric appliances, basic precautions should always be followed, including
the following:
SAVE THESE INSTRUCTIONS
WORK AREA SAFETY
• Keep your work area clean and well lit. Cluttered or dark areas invite accidents.
• Keep bystanders, children, and visitors away while operating an inflator. Distractions can cause
you to lose control.
• Operate inflator in an open area at least 18 in. away from any wall or object that could restrict
the flow of fresh air to ventilation openings.
• Do not operate inflator near flammable liquids or in gaseous or explosive atmospheres. Internal
sparks may ignite fumes.
ELECTRICAL SAFETY
• To reduce the risk of electrical shock, do not put inflator in water or other liquid. Do not place or
store appliance where it can fall or be pulled into a tub or sink.
• Use this product only with batteries and chargers listed in tool/appliance/battery pack/charger
correlation supplement.
PERSONAL SAFETY
• Stay alert, watch what you are doing and use common sense when operating an inflator. Do
not use inflator while tired or under the influence of drugs, alcohol, or medication. A moment of
inattention while operating inflator may result in serious personal injury.
• Do not overreach. Keep proper footing and balance at all times. Proper footing and balance
enable better control of the inflator in unexpected situations.
• Use safety equipment. Always wear eye protection. Dust mask, non-skid safety shoes, hard hat,
or hearing protection must be used for appropriate conditions.
• Eye protection is required to guard against flying fasteners and debris which could cause severe
eye injury.
• Do not wear loose clothing or jewelry. Contain long hair. Loose clothes, jewelry, or long hair can
be drawn into air vents.
• Do not use on a ladder or unstable support. Stable footing on a solid surface enables better
control of the inflator in unexpected situations.
• Do not disassemble the inflator.
• Do not store your inflator in a damp or wet location. Do not store in locations where the
temperature is less than 50°F (10°C) or more than 100°F (40°C). Do not store in outside sheds
or in vehicles.
INFLATOR USE & CARE
• Check hoses for weak or worn condition before each use, making certain all connections are
secure. Do not use if defect is found. Purchase a new hose or notify an authorized service
center for examination or repair.
3