Operation - Armor All AA20TI Manual Del Operador

WARNING!
Do not allow familiarity with this product to make you careless. Remember that a careless
fraction of a second is sufficient to inflict serious injury.
WARNING!
Do not use any attachments or accessories not recommended by the manufacturer of
this tool. The use of attachments or accessories not recommended can result in serious
personal injury.
WARNING!
Do not leave items to be inflated unattended while inflator is in use. These items can burst
and could cause serious injury.
NOTICE: The inflator is capable of inflating to 160PSI. To avoid over inflation, carefully follow
instructions on items to be inflated. To avoid product damage, never exceed recommended
pressures.
BECOME FAMILIAR WITH THE HANDHELD INFLATOR
This handheld inflator may be used for automotive and recreational inflating. This inflator is not
intended for commercial use.
INSTALLING & REMOVING BATTERY PACK
1.1
1. To install the battery pack, align the tongue on the battery pack with the groove in the tool
housing and slide it into place. Insert it all the way until it locks in place with a click (Fig. 1.1).
2. To remove the battery pack, slide it from the tool while pressing the release button on the front
of the pack (Fig. 1.2).
NOTE: For complete charging instructions, see the Operator's Manual for your battery pack and
charger.
WARNING!
Battery tools are always in operating condition. Always remove battery pack from your
tool when you are assembling parts, making adjustments, cleaning, or when not in use.
Removing battery pack will prevent accidental starting that could cause serious personal
injury.
NOTICE: Before using the inflator, read all safety precautions and follow the instructions in the
Battery Pack and Charger sections. The battery pack is not fully charged when it is purchased.

OPERATION

1.2
8