Concept Perfect Clean CP 1010 Manual Del Usario página 81

THE CLEANING AGENT REGULATOR
(When using cleaning agents for different types of surface.)
1. The cleaning agent regulator controls the amount of cleaning solution that is added to the steam.
2. It does not adjust the amount of steam, only the amount of the cleaning solution.
3. If you wish to clean with steam alone, simply turn the regulator to the "OFF" position. Now every time
you press the steam trigger, you will release steam alone.
4. If you wish to use the cleaning agent, simply turn the regulator to the desired setting. Now when you press
the steam trigger, the steam cleaner will release the amount of solution that is indicated on the regulator
as well as steam.
OPERATING STEAM CLEANER
Correct use
Incorrect use
For best results
(When using a cleaning agent for the type of surface intended to clean).
1. Follow the instructions in "Removing and filling the cleaning agent tank" and fill the tank with the detergent
solution for the type of surface. Turn the regulator to "MAX".
C P 1010
1. Press the power button. The power indicator lights up red.
2. If the indicator does not light up, check the "Troubleshooting" section for
more details.
3. The steam cleaner should take between 3-5 minutes to heat up,
the indicator lights up green.
4. When operating the steam cleaner, make sure to keep it levelled during
use. Angling the steam cleaner too far will cause water to leak
from the cleaner.
WARNING: Do not operate the steam cleaner without any water in the water
tank.
WARNING: If you want to avoid steam discharge from the appliance for safety
reasons, use the steam release button lock. By moving the lock lever to the
"locked" position, it will not be possible to press the steam discharge button. To
release this button again, slide the lock lever back to the "unlocked" position.
EN
81