Mounting The Speaker; Pairing The Speaker With A Bluetooth Enabled Device - Impecca ASB-110BT Manual Del Usuario

is included. To replace the battery, push and slide out the bat-
tery door on the remote control. Replace the battery with a new
CR2025 battery with the positive (+) polarity facing up. Slide the
battery door in to the remote control.
NOTE: The SOUNDBAR remote is packaged with a plastic protec-
tion tab. Before operating the remote, gently pull the protective
tab extending out of the remote control's battery door.

MOUNTING THE SPEAKER

1. Measure a width of 15.7 inches on the wall.
2. Mark the position of the mounting screws on the wall using a
pencil.
3. Drill the supplied screws directly into the marks that you have
made on the wall and leave approximately 0.3 inch length to
hook the Soundbar unit.
4. Put the Soundbar unit on the mounting screws. Make sure
they are firm and stable.
PAIRING THE SPEAKER WITH A BLUETOOTH
ENABLED DEVICE
1. Connect the AC power cord into a wall socket.
2. Turn the speaker on by pressing the [ POWER ] button on the
speaker or remote control.
3. Press the [ MODE ] button on the speaker or remote control
to enter Bluetooth Mode. A tone is heard and the Bluetooth
LED indicator light will flash quickly.
4. Keep the speaker and your Bluetooth enabled device within
three feet of each other during the pairing process.
5. Set your mobile phone or other Bluetooth enabled device to
–7–