Assembly; Un-Crate Unit And Install Handlebars; Important - Spyker Spreaders ROS 5 S100-12011 Manual Del Operador

Assembly Instructions
WARNING: AVOID INJURY! ALWAYS WEAR SAFETY GLASSES, STURDY GLOVES AND
APPROPRIATE FOOTWEAR WHEN SERVICING OR MAINTAINING EQUIPMENT.

UN-CRATE UNIT AND INSTALL HANDLEBARS

1. Read, understand and follow all safety instructions
in SAFETY PRECAUTIONS Section (pages 4-5).
2. Remove the top and then the side panels from the
crate.
1017459 Rev. C
3. Carefully cut the nylon straps securing the spreader
to the crate.

IMPORTANT:

DO NOT mistakenly cut a control cable.
4. Remove the handlebar from the shipping plates
on the left and right side of the unit. Discard the
hardware.
Fig. 1
5. Remove the shipping brackets from the unit frame.
Discard the shipping brackets and the hardware.
6. Reinstall the handlebar assembly on the spreader
with six 5/16"-18 x 1.00 hex head bolts and 5/16"
nylon lock nuts as shown in Figure 3. Hardware is
located in the manual bag.
6
Remove
©2016 Spyker Spreaders/A Brinly-Hardy Co.
Fig. 2