Operations
Before You Clean
1. Move furniture to another area if cleaning
the entire room (optional).
2. Vacuum area thoroughly before deep
cleaning.
3. Plan your cleaning route to leave an exit
path. It is best to begin cleaning in the
corner farthest from your exit.
Carpet Cleaning
1. Remove Dirty Water Tank. Pull Dirty Water
Tank handle to upright position and lift up to
remove Dirty Water Tank.
2. Lift Clean Water Tank from the base of
machine.
A. Unscrew cap on top of the Clean Water
Tank. Fill tank to FILL line with clean, hot
tap water.
B. Measure Sanitaire
on tank. Fill cap to line twice for each
full tank of water. Always use genuine
Sanitaire formulas to maximize cleaning
and for the safety of your machine
C. Screw cap back onto Clean Water Tank and
place tank onto base of the machine.
3. Replace Dirty Water Tank securely on top
of the Clean Water Tank and push handle
back to lock into place.
4. Plug into a proper outlet and turn the Power
Switch to the ON ( I ) position.
5. Recline handle by pushing down on the
green lever on the back of the machine
while pulling back.
6. Cleaning strokes. While pressing the
trigger, make one slow forward wet pass
and another back. Let the formula and
DirtLifter
PowerBrushes do the work for you.
®
Note: Your machine is equipped
with a circuit breaker that will
automatically shut off the brush if
a large or loose object is caught
in the Brush Roll. If that happens,
be sure to unplug your machine,
remove the foreign object and then
plug machine in to reset the circuit
breaker.
4 www.sanitairecommercial.com
formula using cap
®
ATTENTION
Some Berber carpets have a tendency to fuzz with
wear. Repeated strokes in the same area with an
ordinary vacuum or deep cleaner may aggravate
this condition.
1.
2.
2C.
3.
5.
1.
2A.