Sanitaire THE ULTIMATE TIME MACHINE 6100 Serie Guia Del Usuario página 7

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Maintenance and Care
Brush Removal and Replacement
1. Turn OFF the machine and unplug from
the outlet.
2. Remove the Dirty and Clean Water
Tanks from the base of the machine.
3. While standing behind the unit, lay the
unit on its side (cord side down).
4. Looking at the bottom of the unit,
find the center of the brush carriage
where the carriage latch is located.
It is between the brush assembly and
wheels.
5. Pull the brush carriage towards you
with one hand until it stops. Pinch the
carriage latch with the other hand while
pulling the carriage towards you. The
carriage should swing out to access
brush end cover.
6. Remove three screws from endcap. Pull
endcap off to release brush roll.
7. With cover removed, the brush comes
out easily by tilting the loose end out of
the carriage.
8. To replace the Brush Roll to the unit,
place the large open end of the brush
onto the carriage and tilt opposite end
back into place.
9. With the brush sitting relatively straight
up and down by itself, place endcap
back on top and replace three screws.
The brush will need to be held and
centered to the cover while placing it
back on.
10. Spin the brush by hand to make sure it
turns freely with some minor resistance
from the motor. Push brush carriage
back into place with a light pull against
the lock.
4.
5.
6A.
7.
9.
www.sanitairecommercial.com 7
3.
6B.
8.
10.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

The ultimate time machine sc6100a

Tabla de contenido