Internal Cleaning Instructions; Cleaning Instructions; Replacement Sound-Absorbing Panels - F.P.Z. SCL K07 Instrucciones

Compresores - aspiradores de canal lateral
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

3.

INTERNAL CLEANING INSTRUCTIONS

CAUTION!
Internal deposit build up can cause:
performance variations;
alteration in clearances resulting in seizing;
out of balance rotor.
3.1

CLEANING INSTRUCTIONS

In case it is necessary to clean the inside of the blower, proceed
as follows:
1. Remove in order #915 and #902 screws placed on #162
cover.
2. Remove #162 cover by using the two threaded holes placed
on cover itself.
3. Remove the #900 screw and #365 washer.
4. Remove the #360 bearing cover and extract the #321
bearing using a bearing puller.
N.B.: The #935 shims washers are included when necessary to
accomodate the axial clearance. Be careful not to misplace.
5. Remove the #230 impeller, using a puller if necessary.
162
360
915
321
365
900
935
423
Cover extraction's
threaded holes
230
902
GB - 16/39
6. Clean and reassemble in reverse order.
If needed, reconstruct #423 seal using Loctite 598 or similar,
after cleaning the sealing surfaces of any existing sealant.
3.2

REPLACEMENT SOUND-ABSORBING PANELS

If needed, replace the foam sound-absorbing panels, proceed as
follows:
1. Remove #723 flange and related #426 O-Ring by removing
#908 screws.
2. Remove #906 screws.
3. Take away the #700 silencers from the unit, being careful
not to lose the #424 gaskets.
4. Extract the #720 panels from the silencer housings.
5. Clean up the #710 retaining screen.
6. Replace and reassemble proceeding in reverse order,
remembering to include the #424 and #426 gaskets.
If needed, reconstruct #425 seal using Loctite 598 or similar,
after cleaning the sealing surfaces of any existing sealant.
424
710
720
425
723
426
906
700
908

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Scl k75Scl k08Scl k09Scl k10Scl k11

Tabla de contenido