Lagos Paint TROTTER REFINISH Manual De Montaje Y Utilización página 16

EN
KIT CONTENT
PACKAGING
UNPACKING
MOUNTING
SAFETY INSTRUCIONS
INSTRUCTIONS FOR USE
USAGE RECOMMENDATIONS
ASPIRATIONS SYSTEM
FILTERS REPLACEMENT
CONTROL PANEL
TECHNICAL FEATURES
WARRANTY
SPARE PARTS
KIT CONTENT
paintTROTTER
A box containing:
• 1 box of 100 piercing screws of 4,8 x 16 mm
• 1 plastic film dispenser
• 1 plastic film distributor
• 1 CD ROM including mounting and usage instructions
PACKAGING
PaintTROTTER is packed using a wooden boxpallet to prevent
possible damage caused during transport.
The pallet design allows the movement through cargo transport
vehicles. Check the signs on the pallet to locate the fixation
points.
Remove the box boards and plastics to start working with the
machine.
UNPACKING
1. Place the pallet in a firm and flat floor. Make use of a free
surface for mounting the paintTROTTER.
2. Separating the structure with the light.
3. Remove from the pallet the input filter structure. Slide it up
until the front wheels rest on the ground. Then slide and
place the rear wheels on the floor.
4. Lift up the structure with the aspiration filter using a forklift.
Remove the pallet and place the equipment down on the
ground..
......................... 14
......................... 14
......................... 14
......................... 14
......................... 16
......................... 17
......................... 17
......................... 17
......................... 20
......................... 21
......................... 21
......................... 21
......................... 21
MOUNTING
1. Place the structures in the position shown in this image to
make easy the following assembly.
16