Step2 Kitchen 5F63F4C Hoja De Instalación

Fun with Friends
Kitchen
TM
For assistance or replacement
parts please contact :
The Step2 Company, LLC.
10010 Aurora-Hudson Rd.
Streetsboro, OH 44241 USA
1-800-347-8372 USA & Canada Only
(330)656-0440
www.step2.com
A
B
C
11 x 1-7/8" (4.76 cm)
2 x 3/4" (1.9 cm)
Required/ Requis / Erforderlich/Componentes necesarios/ Funziona con/
VereistNecessário/ Wymagane/ 需要 /
2 "AA/LR06" batteries, (NOT INCLUDED) for burner.
2 piles «AA/LR06 » (NON INCLUSES) pour le brûleur.
2 "AA/LR06" Batterien (NICHT ENTHALTEN) für Herd.
2 pilas AA/LR06 (NO INCLUIDAS) para el fuego de la cocina.
2 batterie "AA/LR06" (NON INCLUSE) per il bruciatore.
2 'AA' batterijen, (NIET MEEGELEVERD) voor brander.
2 Pilhas "AA/LR06" (NÃO INCLUÍDAS) para o bico.
2 baterie „AA/LR06" (NIE DOŁĄCZONO)do palnika.
2 节适用于煤气头的"AA/LR06"电池（不包括）。
.‫06"، (غير موجودة مع املنتج) للشعلة‬RL/AA" ‫بطاريتان‬
5F63F4C
5F63FBD
Step2 UK LTD
Great Bank Road
Wingates Industrial Estate
BOLTON
BL5 3XU
UK freephone: 0800 393159
Step2 UK website: www.step2uk.com
Dx6
E
F
G
H
I
‫مطلوب‬
X 2
WARNING:
CHOKING HAZARD - Small parts. Sharp points.
Adult assembly required.
Intended for use by children from ages 2 years and up.
OBSERVE THE FOLLOWING STATEMENTS AND WARNINGS TO REDUCE THE
LIKELIHOOD OF SERIOUS OR FATAL INJURY.
SAVE THIS SHEET FOR FUTURE REFERENCE.
INSTALLATION
• Adult supervision required.
• Instruct children not to use product until properly assembled.
• To minimize risks posed by drill shavings, screws are designed to pierce the plastic
and form their own threads. Use caution. Do not over-tighten screws or they will not
hold parts together appropriately.
INSPECT THIS PRODUCT BEFORE EACH USE. TIGHTLY SECURE CONNECTIONS
AND REPLACE DAMAGED OR WORN COMPONENTS. CONTACT THE STEP2
COMPANY FOR REPLACEMENT PARTS.
CLEANING INSTRUCTIONS
• Electronic Components: Do not submerge in water or spray liquid directly on unit.
Use mild detergent solution. Wipe with damp cloth.
• General Cleaning: Use mild soapy water.
• Parents should thoroughly wash accessories before use.
DECAL APPLICATION
Clean and dry area thoroughly. Center decal in area. Apply pressure from center to
outer edge.
DISPOSAL INSTRUCTIONS
Please recycle when possible. Disposal must be in compliance with government
regulations.
IMPORTANT
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium)
batteries.
Do not recharge non-rechargeable batteries.
Rechargeable batteries are to be removed from the toy before recharging.
Rechargeable batteries are to be charged only under adult supervision.
Batteries must be inserted with the correct polarity.
Exhausted batteries are to be removed from the toy.
The supply terminals are not to be short circuited.
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS
SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT
CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY
INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE
UNDESIRED OPERATION
THIS CLASS B DIGITAL APPARATUS COMPLIES WITH CANADIAN ICES-003.
WARNING: CHANGES OR MODIFICATIONS TO THIS UNIT NOT EXPRESSLY APPROVED
BY THE PARTYRESPONSIBLE FOR COMPLIANCE COULD VOID THE USER'S AUTHORITY
TO OPERATE THE EQUIPMENT.
NOTE: THIS EQUIPMENT HAS BEEN TESTED AND FOUND TO COMPLY WITH THE LIMITS
FOR A CLASS B DIGITAL DEVICE, PURSUANT TO PART 15 OF THE FCC RULES. THESE
LIMITS ARE DESIGNED TO PROVIDE REASONABLE PROTECTION AGAINST HARMFUL
INTERFERENCE IN A RESIDENTIAL INSTALLATION. THIS EQUIPMENT GENERATES, USES,
AND CAN RADIATE RADIO FREQUENCY ENERGY AND, IF NOT INSTALLED AND USED
IN ACCORDANCE WITH THE INSTRUCTIONS, MAY CAUSE HARMFUL INTERFERENCE TO
RADIO COMMUNICATIONS. HOWEVER, THERE IS NO GUARANTEE THAT INTERFERENCE
WILL NOT OCCUR IN A PARTICULAR INSTALLATION. IF THIS EQUIPMENT DOES CAUSE
HARMFUL INTERFERENCE TO RADIO OR TELEVISION RECEPTION, WHICH CAN BE
DETERMINED BY TURNING THE EQUIPMENT OFF AND ON, THE USER IS ENCOURAGED
TO TRY TO CORRECT THE INTERFERENCE BY ONE OR MORE OF THE FOLLOWING
MEASURES:
- REORIENT OR RELOCATE THE RECEIVING ANTENNA.
- INCREASE THE SEPARATION BETWEEN THE EQUIPMENT AND RECEIVER.
- CONNECT THE EQUIPMENT INTO AN OUTLET ON A CIRCUIT DIFFERENT FROM
THAT TO WHICH THE RECEIVER IS CONNECTED.
- CONSULT THE DEALER OR AN EXPERIENCED RADIO/ TV TECHNICIAN FOR HELP.
193857 5/20/16
1