Summer 27284AZ Manual De Instrucciones página 3

(2)
(8 conjuntos)
(4)
Mide la anchura de la apertura donde usted quiere instalar la puerta y seguir debajo de correcta configuraciones
para la apertura. Refiera por favor a las Figuras A, B & C para la orientación correcta del cada panel necesitado.
• Panel A + Panel de la Puerta + Panel A:
111.8 cm – 132.1 cm (44" – 52")
• Panel A + Panel de la Puerta + Panel A + Panel B:
132.1 cm – 157.5 cm (52" – 62")
• Panel B + Panel A + Panel de la Puerta + Panel A + Panel B:
157.5 cm – 182.9 cm (62" – 72")
(2)
(2)
(Prefabricado
a Panel A)
(4)
(8)
(8)
If not using Panel B, please remove Panel A lower insert by unscrewing
from gate (Figure D).
(2)
Connect the panels to each other by sliding one panel inside the other one until
the desired holes on the upper and lower rails of each panel line up. Insert the Post Screw
Receivers into aligned holes; insert and tighten Post Screws securely (Figure E). Repeat for
bottom rail until they are securely tightened.
Thread spindles into the upper and lower rails of the outermost panels (Figure F).
Place Hole Guards on top rails over holes in top rails on each side of Door Panel
(Figure G). Repeat for holes on bottom panels (Figure H).
(2)
Place Lower Latch on the floor and (if mounting into wood) screw into wall using
supplied Wood Screws (Figure I). Repeat on opposite wall for other Lower Latch.
Screws are provided for mounting the latches directly to wood.
If mounting into wallboard, use the Wall Anchors and Screws provided. If you are
mounting the gate to another surface, purchase and use the appropriate hardware.
If Wall Anchors are needed:
a) Pre-drill a hole in the wall (7/32" or 5.5mm drill bit)
b) Insert the Wall Anchors (included) into the hole with a hammer, tap gently on the end
until the Wall Anchor is flush with the wall.
Adjust lower spindles in or out of gate until they match.
Lift the gate up and drop down into the Lower Latches until the lower
spindles are secure in Lower Latches (Figures J & K).
Place Upper Latch over upper spindle (Figure L). Adjust spindle
until Upper Latch is in place and flush against wall. Screw latch into wall
(if using wood) in the upper hole (Figure M).
Rotate Upper Latch 90 degrees (to the
right or left) by lifting up the bottom of the tab
on the bottom of the Upper Latch and rotating
(Figure N). Remove upper spindles out of latch
and screw bottom hole of Upper Latch into wall
using the Wood Screws provided (Figure O).
If mounting into drywall, mark upper
and lower holes and follow guidelines under
in Step 5.
Repeat Steps 6
and 7 for Upper Latch
on other side of the gate.