Tabla de contenido
Publicidad
CARE AND MAINTENANCE
Cooling System
This refrigerator is inclusive of a "Frost Free" type
cooling system, which means you never have to
defrost the freezer compartment. Defrosting is done
automatically by means of a defrost heating element
and a defrost timer factory-programmed to operate
(cycle) approximately every 8 hours. The defrost
water is routed into a defrost pan located directly
above the compressor, where it then evaporates.
Cleaning
Before cleaning the refrigerator or freezer, always
disconnect the refrigerator from the power supply. To
clean the inside, use a soft cloth and a solution of a
tablespoon baking soda to one quart (4 cups) of water,
or a mild soap suds solution or mild detergent. Wash
ice cube tray, drip tray, and glide out shelves in a mild
detergent solution, then wipe dry with a soft cloth.
Clean the outside with a damp soft cloth and some
mild detergent or appliance cleaner.
Setting the Thermostat
The thermostat setting can be adjusted from 1
(minimum setting) through Maximum (coldest
setting). We recommend setting the thermostat at 4
(medium setting). However, if you find this setting
inadequate for your cooling requirements, adjust as
needed by rotating the thermostat dial. The thermostat
dial is located on the front top section of the
refrigerator compartment. The thermostat controls
temperature for both the freezer and refrigerator
compartments.
Vacation Time
For short vacation periods, leave the control knob at
the usual setting. During longer absences;
a) remove all food
b) disconnect from electrical outlet
c) clean the refrigerator thoroughly, including defrost
pan.
Power Failure
Most power failures are corrected within an hour or
two, and will not affect your refrigerator
temperatures. However, you should minimize the
number times you open the door while the power is
off. During power failures of longer duration, take
steps to protect your food, for
example, by placing dry ice on top of packages.
If You Move
Remove, or securely fasten down, all loose items
inside the refrigerator. To avoid damaging the leveling
legs, turn them all the way into the base.
Some Important Rules for the Correct Use
of the Refrigerator
• Never place hot foods in the refrigerator
• Beverages should be stored in sealed containers
• Foods to be stored for a long time should be
wrapped in cellophane or polyethylene, or kept in
glass containers. Never place spoiled food in the
cabinet.
• Don't overload the cabinet
• Don't open the door unless necessary
• Should the refrigerator be stored without use for
long periods, it is suggested, after careful cleaning, to
leave the door ajar to allow the air to circulate inside
the cabinate in order to avoid the possible formations
of condensate, mold, or odors.
Food Storage Suggestions
Fresh Food Compartment
• Never cover food compartment shelves with
aluminum foil or any other shelf covering material
which may prevent air circulation
• Always remove porous store wrapping paper from
meats, poultry, and fish. Meats should be wrapped
individually and placed in a dish for storage. Wrap
fish and poultry in foil or heavy waxed paper. Most
fish should be used the same day of purchase.
Packaged meats such as ham, bacon, dried beef, or
frankfurter, store best in their original packages.
• Allow warm foods to cool to room temperature
before placing them in the refrigerator.
• Always cover open dishes of food, especially
leftovers. Use leftovers within 2 or 3 days.
Vegetable Crisper
The tray at the bottom of the refrigerator is covered to
retain moisture. The crisper compartment will enable
you to store vegetables and fruits which would
otherwise dry out rapidly. The humidity level inside
the crisper drawer can be controlled by adjusting the
"damper" control (white slider) located on the front of
the drawer.
4
I
NSTRUCCIONES PARA CAMBIAR EL SENTIDO ENQUE SE ABRE LA PUERTA
ADVERTENCIA
Para evitarse lesiones personales y daños a la propiedad,
recomendamos que otrapersona lo ayude durante el
proceso de cambiar de sentido en que se abra la puerta.
1) Para lograr acceso a la unidad de la bisgara inferior, incline
el refrigerador hacia atrás, o tiendalo sobre el dorso (Fig.A).
2) Saque los dos pies graduables ubicados en la parte del
antera del refrigerador.
3) Saque los tornilios que fija la unidad de la bisagra inferior
al refrigerador (Fig.A).
4) Saque la unidad principal de la puerta del refrigerador
(Abra la puerta y tire hacia abajo).
5) Saque los tornilios de la unidad de la bisagra del medio.
Luego saque la bisagra y la puerta del congelador (Fig.B).
6) Saque (des tornille) el eje de la bisagra superior en el lado o
puesto del refrigerador (Fig.C).
7) Vuelva a instalar el eje de la bisagra superior en el lado o
puesto del refrigerador (Fig.C).
8) Saque el tapon de la bisagra y el manguito de la puerta, ubicados en la parte superior e inferior de cada
unidad de puerta.
9) Intercambie las posiciones (Es decir, el tapón al lado derecho de la puerta, el manguido al lado izquierdo de
la puerta).
10) Vuelva a instalar la unidad de la puerta del congelador en el refrigerador.
11) Vuelva a instalar la unidad de la bisagra del medioen el lado opuesto del refrigerador.
12) Antes de apretar los tornillos de la bisagra, verifique que la unidad de la puerta esté debidamente alineada
con el refrigerador.
13) Vuelva a instalar la unidad de la puerta principal en el refrigerador.
14) Vuelva a instalar la unidad de bisagra inferior en el lado o puesto. Asegúrese de cambiar el manguito y
tornillo en los lados o puestos en la parte inferior de la unidad.
15) Antes de apretar los tornillos de la bisagra inferior, verifique que la unidad de la puerta esté debidamente
alineada con el refrigerador.
16) Vuelva a instalar los pies graduables.
AHORA, EL PROCESO HA TERMINADO.
Fig. A
Fig. B
15
Publicidad
Tabla de contenido
