Important Notices; Product Limitations - DeWalt MOBILELOCK DS600 Guia De Inicio Rapido

CAUTION: POTENTIAL EQUIPMENT MALFUNCTION OR
FAILURE. Do not operate with a damaged power supply cord
or plug. Damage to the equipment may occur. Protect the power
supply cord from being walked on or pinched particularly at plugs,
convenience receptacles and the point where they exit from the
product. Do not pull on cords or cables. When unplugging the
cord from an electrical outlet, grasp and pull the cord by the plug.
If a cord or plug is damaged, have it replaced immediately.
CAUTION: POTENTIAL EQUIPMENT MALFUNCTION OR
FAILURE. This equipment is supplied with a wall-mount power
supply designed specifically to operate on 120 V 60 Hz. If the
cord is missing or damaged, replace only with D
supply specified for this equipment to avoid product damage.
CAUTION: POTENTIAL EQUIPMENT MALFUNCTION OR
FAILURE. To avoid potential damage caused by a power surge,
utilize a surge protector.

Important Notices

• This product is not user serviceable. There are no user
serviceable parts inside the product. Unauthorized service will
void the warranty.
• Clean only with a dry cloth.
• Although the noise level and duration of the siren are below
OSHA limits, the loud noise from the sirens may startle the user
• Similar to cellular phone service, the DS600 base unit must be
shut down in accordance with FAA guidelines prior to shipping
by air or bringing aboard an airplane.
• MOBILELOCK™ is a Trademark of Mobilelock LLC. All other
trademarks in this manual are the properties of their respective
owners.

Product Limitations

Although this unit is designed as a personal property protection
device, it does not guarantee protection against burglary or other
emergencies. Any alarm is subject to compromise or failure-to-warn
for a variety of reasons including, but not limited to, the following:
• An intruder may gain access through unprotected openings.
An intruder with criminal intent, technical knowledge, or
jamming devices, may bypass the alarm system.
• This product will not operate without power. The equipment
has a rechargeable battery. If the battery has not been
adequately charged, the product will not operate.
• Signals sent by the cellular radio may be blocked before they
reach the server. Even if the signal path has been recently
checked during a routine test, blockage can occur if the
cellular signal is lost.
• A cellular signal is needed to arm, disarm, accept programming
changes and transmit alarm signals. If reception is not
available, equipment is out of service, or the cellular company
makes changes to its facilities, the signal will not be received.
• A cellular signal is required to provide an assisted-GPS
location. To provide the most accurate location, the unit must
be outdoors with line of sight to the GPS satellites.
• If the product cannot find strong satellite signals, the location
provided may be slower, less accurate, or may not work at all.
The MOBILELOCK™ base unit provides only an approximate
location, often within 150 feet (45 meters) but sometimes much
farther from the actual location.
• If the unit is removed from the asset, the GPS location is only
associated with the MOBILELOCK™ unit, not the asset.
• The GPS satellites are controlled by the U.S. government
and subject to changes implemented in accordance with the
Department of Defense AGPS user policy and the Federal Radio
Navigation Plan. These changes may affect performance.
• This product is a self-installed alarm. Carefully follow all
instructions. Improper installation may compromise the
operation of this equipment.
• This alarm should be tested regularly to make sure all sensors
and the cellular signal are working properly.
• Even if the product responds to an intrusion as intended, the
users may not receive the alarm phone call if the user's cell
WALT power phone is out of cellular coverage or a problem with cellular
e
phone provider exists.
• Even if the product responds to an intrusion as intended, the
user may have insufficient time to protect their assets and
property. Even after being contacted, the authorities may not
respond appropriately.
• Warning devices such as sirens may not alert people if they are
out of range or not on the premises. Persons may not hear the
warning if the alarm is muffled by a radio, operating equipment,
appliances or passing traffic. Alarm warning devices, however
loud, may not warn hearing-impaired people.
• Despite advanced design and regular testing, this equipment,
like other electrical devices, is subject to component failure.
• Installing this alarm may make one eligible for lower insurance
rates, but an alarm is not a substitute for insurance.
Federal Communications Commission
(FCC) Part 15 Statement
• This equipment has been tested and complies with Part 15
of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference,
and 2) the device must accept any interference received,
including interference that may cause undesired operation.
• If this equipment does cause harmful interference to radio or
television reception, which can be determined by placing the
equipment in standby mode, try to correct the interference by
one or more of the following measures:
1. Reorient the antenna of the radio/TV experiencing the
interference.
2. Relocate the receiver with respect to the radio/TV.
3. Move the antenna leads away from any wire that runs to the
receiver.
4. Plug the receiver into an outlet on a different electrical circuit
from the radio/TV experiencing the interference.
5. Additional suggestions can be found in the following booklet
prepared by the Federal Communications Commission:
"Interference Handbook" This book is available from the
U.S. Government Printing Office, Washington, DC 20402.
• Any changes or modifications to the equipment, not specifically
approved by Mobilelock LLC, can void the user's authority to
operate the equipment.
FCC ID: 2AF36-DS600