Faucet Installation - Pfister SANTIAGO LF 42 Serie Manual De Usuario

Thank you for purchasing this Pfister product. All Pfister products are carefully engineered, and factory tested to provide long
trouble-free use under normal conditions. This product is easy to install using basic tools and our easy to follow illustrated
instructions. If you have any questions regarding this product, call 1-800-Pfaucet (1-800-732-8238).
1 BEFORE PROCEEDING
WARNING: Read all the instructions completely before proceeding. Pfister
recommends calling a professional if you are uncertain about installing this product!
This product should be installed in accordance with all local and state plumbing and
building codes.
2
2 SHUT OFF WATER SUPPLY
Locate water supply inlets and shut off the water supply valves. These are usually found
under the sink or near the water meter. If you are replacing an existing faucet, remove
the old faucet from the sink and clean the sink surface thoroughly.
3
3 TOOLS RECOMMENDED
• Plumber's putty • PTFE Plumber's Tape
• Adjustable wrench • Pliers
• Cloth
Your installation may require new supply lines and / or shut-off valves or other additional
tools.
4
A
B
H
4 CHECKING THE CONTENTS OF THE BOX
Upon opening the box, check to ensure that all of the following items are included.
A Faucet D Deckplate
B Lift Rod E Putty Plate
C Base Plate F Metal Washer
If any of these items are missing, please contact Pfister Consumer Service at
1-800-Pfaucet (1-800-732-8238).
• Slotted screwdriver
• Flashlight
C
D
E
F
G
G Long Nut
H Pop-up Assembly
ENGLISH

FAUCET INSTALLATION

5
5 INSTALLING FAUCET WITH SINGLE HOLE MOUNTING
Place a bead of plumber's putty in the groove along the bottom outer edge of Base Plate
(5A). Place Base Plate onto top of Hole (5B) of sink. From above sink, insert Threaded
Shank (5C) and Supply Tubes (5D) through hole (5B) on sink.
6
6D
6 INSTALLING FAUCET WITH DECKPLATE
Ensure that the Plastic Putty Plate (6A) is pressed on the Deckplate (6B). Place a
bead of plumber's putty in the groove along the outer edge of the Putty Plate (6A).
Assemble Deckplate (6B) and Putty Plate (6A) to Faucet Body (6C). With the handle
and spout facing forward, carefully install the Faucet Supply Tubes (6D) through the
center hole of sink (6E).
2
5C
5D
6C
6B
6E
5A
5B
6A