Faucet Installation - Pfister KENZO 42 Serie Guia De Inicio Rapido

Grifo monomando para el baño
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Thank you for purchasing this Pfister product. All Pfister products are carefully engineered, and factory tested to provide long
trouble-free use under normal conditions. This product is easy to install using basic tools and our easy to follow illustrated
instructions. If you have any questions regarding this product, call 1-800-Pfaucet (1-800-732-8238).
1 BEFORE PROCEEDING
WARNING: Read all the instructions completely before proceeding. Pfister
recommends calling a professional if you are uncertain about installing this product!
This product should be installed in accordance with all local and state plumbing and
building codes.
2
2 SHUT OFF WATER SUPPLY
Locate water supply inlets and shut off the water supply valves. These are usually found
under the sink or near the water meter. If you are replacing an existing faucet, remove
the old faucet from the sink and clean the sink surface thoroughly.
3
3 TOOLS RECOMMENDED
• Plumber's putty
• Slotted screwdriver
• Pliers
• Flashlight
Your installation may require new supply lines and / or shut-off valves or other additional
tools.
4
J
H
B
4 CHECKING THE CONTENTS OF THE BOX
Upon opening the box, check to ensure that all of the following items are included.
A Spout Body
B Pop-Up Assembly
D Long Nut
E Mounting Washer
G Deck Plate
H Seal Base
If any of these items are missing, please contact Price Pfister Consumer Service at
1-800-Pfaucet (1-800-732-8238).
• Adjustable wrench
• Cloth
A
G
F
C
E
D
C Pop-Up Rod
F Putty Plate
J Spout Base
ENGLISH

FAUCET INSTALLATION

5
5A
BOTTOM GROOVE
5 INSTALLING FAUCET WITH SINGLE HOLE MOUNTING
Following manufacturer's recommendations on use, apply plumber's putty into putty
groove in bottom of Seal Base (5A). Ensure that Seal Base (5A) is pressed onto Spout
Base (5B). Place Spout Base (5B) and Seal Base (5A) onto the bottom of Faucet Body
(5C). From above sink, insert Faucet Supply Tubes (5D) through Hole (5E) on sink.
6
6A
BOTTOM GROOVE
6 INSTALLING FAUCET WITH DECK PLATE
Following manufacturer's recommendations on use, apply plumber's putty into putty
groove in bottom of Putty Plate (6A). Ensure that the Plastic Putty Plate (6A) is pressed
on the Deck Plate (6B). Assemble Deck Plate (6B) and Putty Plate (6A) to Faucet Body
(6C). From above sink, insert Faucet Supply Tubes (6D) through Hole (6E) on sink.
2
5C
5B
5A
5D
5E
6C
6B
6A
6D
6E

Publicidad

Tabla de contenido
loading

Tabla de contenido