Symmons SLS-0142-1.5 Manual De Operaciones Y Mantenimiento página 3

Installation
If replacing an older faucet
ensure water supply is turned
OFF before removing, then
turn faucet control valve ON to
relieve water pressure.
1) Insert hoses from faucet body
and threaded rods (J) through
mounting sink hole.
2) Install mounting nuts (M), rubber
washer (K) and metal washer (L) to
threaded rods (J). Turn mounting
nuts clockwise to secure body to
deck surface.
J
K
L
1
1
M
3) Attach supply lines to shut-off
valves and hand tighten. Using a
wrench, finish with one half-turn.
DO NOT overtighten.
1
HOT water supply line is on
right side of faucet.
4) Insert flange (N2) into drain
opening (N3 gasket optional if
plumber putty is used). From
J
below, attach gasket (N4),
washer (N5), flange nut (N6) and
drain body (N7) to flange (N2) (2-3
turns until hand tight).
PLUMBER
PUTTY
Note: Make sure drain cavity (on
drain body) faces rear of sink.
2
1
2
N2
N3
1
2
N4
N5
N7
N6
3
3
5) Apply plumber tape to tail piece
(N9) and attach to drain body (N7).
From below, tighten flange nut (N6)
to secure drain assembly. DO NOT
overtighten.
N6
N7
1
N9
6) Insert stopper (N1) into flange (N2)
and rotate to desired position.
N1
N2
Non Removable
2
Removable