Bissell PROHEAT 1799 Serie Guia Del Usuario página 12

Rinsing Your Carpet (optional)
Rinsing is an optional step that can be done during the cleaning process by
1
switching to the water rinse setting, or it can be done after the carpeted area has
been cleaned.
Choose the Water Rinse setting on the SmartMix® Dial, Be sure to rinse out your
tank if Boost was added in with your water. Use the Water Rinse setting with water
only. Follow the same path as you did for cleaning, taking care to do a forward
(wet) stroke by pressing the trigger, a backward (wet) stroke, and a forward and
backward (dry) stroke, releasing the trigger. Continue this until the water you see
coming up the nozzle is clear.
Emptying the 2-in-1 Tank
1
1- Press the Power Switch OFF. Remove the 2-in-1 Tank from
the base by lifting up on the tank's carry handle.
2- Carry the tank like a bucket to where you'll dispose of the
collection water. Rotate the carry handle to unlatch the lid and
empty the tank.
NOTE: You may notice hair & debris deposits on the carpet or in the tank that
were loosened by the cleaning action (especially with new carpet that may
never have been deep cleaned before). This debris should be picked up and
thrown away.
To Continue Cleaning
1
1- Fill the 2-in-1 Tank
again, following the
instructions on pages
8 and 9.
2- Make sure the tank lid is secure and return the tank to
the machine. Follow cleaning instructions on pages 10
and 11 to continue cleaning. *Don't forget to check the
formula tank and refill as needed!
12 12
www.BISSELL.com
2
2
After each use, remove and
rinse the lint screen located
on the tank lid.
3
Rinse (optional)
Choose the Water Rinse
setting on the SmartMix
Dial and follow rinse
instructions at the top of
this page.