Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

Protect yourself. Before installing, read the entire instructions
carefully and save them for future reference.
Date installed:________________________________________
FIXTURE PACKING LIST
Description
1) Housing Assembly ............................................................... 1
2) Photocontrol ........................................................................ 1
3) 1" Bolts* ............................................................................... 2
4) 2" Wood Screws* ................................................................. 3
5) Cover Plate* ........................................................................ 1
6) Wire Nuts* ........................................................................... 3
7) Diffuser* ............................................................................... 1
*Contained in parts packs
Mounting Hardware Included
Waterproof Supply Fittings & Conduit
will be required - Purchase Separately
Silicone Sealant Required
REQUIRED TOOLS:
Dusk to Dawn LED Area Light
Model Number(s):
OLAL2
INSTALLATION INSTRUCTIONS
If this fixture fails to operate properly, use the guide below to
diagnose and correct the problem.
Trouble Shooting Guide
Verify that power is turned on at switch and breaker
Verify that fixture is wired properly
Verify that line voltage is correct.
Quantity
Test if Photocontrol works properly
The photocontrol in this fixture is designed to turn on fixture
light at low light levels.
If light does not come on or stays on:
Test if Photocontrol works properly:
Cover Photocontrol - Light should come on.
Shine a flashlight into Photocontrol - Light should go off.
If fixture cylcles on and off:
Light reflecting back off any surrounding surfaces enters the
photocontol. To correct problem, reposition the fixture or eliminate
reflective surface.
If further technical assistance is required, contact: Technical
Support at: (800) 748-5070
This LED light provides low maintenance service with no bulbs
to change. Clean surfaces with mild soap and water. Do not use
abrasive materials such as scouring pads or powders, steel wool
or abrasive paper.
WARNING: There are no user serviceable parts inside fixture.
page 1
UOLAL2_Rev 6/14

Publicidad

Tabla de contenido
loading

Resumen de contenidos para Lithonia Lighting OLAL2

  • Página 1 INSTALLATION INSTRUCTIONS Dusk to Dawn LED Area Light Model Number(s): OLAL2 Protect yourself. Before installing, read the entire instructions If this fixture fails to operate properly, use the guide below to carefully and save them for future reference. diagnose and correct the problem.
  • Página 2: Risk Of Electric Shock

    Lithonia Lighting warranty. ► Do not exceed maximum wattage marked on luminaire label. ► Follow all manufacturer’s warnings, recommendations and restrictions Failure to follow any of these instructions could void product warranties.
  • Página 3: Installation Instructions

    INSTALLATION INSTRUCTIONS 1. Remove fixture components and parts pack. Check to ensure 2) Photocontrol Figure A all parts are included. Note: Account for small parts and destroy packing material, as these may be hazardous to children. 1) Housing Assembly Turn OFF Power at circuit breaker box! CAUTION: Do not rely on wall switch alone to turn off power.
  • Página 4: Model Number(S)

    E S P A Ñ O L GUÍA DE PASO-A-PASO Crepúsculo al Amenecer - Area la Luz LED Model Number(s): OLFL2 Si este luminario falla de operar apropiadamente, use la siguiente Antes de instalar, lea estas instrucciones guía para diagnosticar y corregir el problema. cuidadosamente y guárdelas para futura referencia.
  • Página 5 E S P A Ñ O L INFORMACIÓN IMPORTANTE DE SEGURIDAD LEA Y SIGA LAS INSTRUCCIONES DE INSTALACIÓN. • Para reducir el riesgo de muerte, lesiones personales o daño a la PRECAUCIÓN propiedad que pueda surgir de incendios, choques eléctricos, cortes, RIESGO DE DAÑO PARA EL PRODUCTO abrasiones, caída de partes y otros peligros lea todas las advertencias e instrucciones incluidas en la caja o su interior, además de las etiquetas...
  • Página 6: Conexión Del Suministro Eléctrico

    E S P A Ñ O L GUÍA DE PASO-A-PASO 1. Quite los componentes del luminario y el paquete de piezas. Verifique que todas las piezas estén incluidas. Nota: Tenga cuidado con las piezas pequeñas y destruya el material de embalaje, ya que pueden ser peligrosos si están al alcance de niños.
  • Página 7: Crépusculaire - Éclairage De Périmètres

    F r a n ç a i s DIRECTIVES D’INSTALLATION Crépusculaire - Éclairage de Périmètres Numéro des modèle OLAL2 Si l’appareil ne fonctionne pas adéquatement, veuillez vous servir du guide ci-dessous afin d’identifier et corriger le prob- Pour votre propre protection. Avant de procéder à...
  • Página 8: Importantes Mesures De Sécurité

    F r a n ç a i s IMPORTANTES MESURES DE SÉCURITÉ VEUILLEZ LIRE ET RESPECTER TOUTES LES CONSIGNES DE SÉCURITÉ! • Afin de réduire le risque de blessures personnelles ou de mort, ou ATTENTION d’endommager le matériel en raison d’un incendie, d’un choc électrique, RISQUE D’ENDOMMAGEMENT DU PRODUIT de la chute de pièces, de coupures/abrasions ou de tout autre danger, lisez tous les avertissements et instructions compris dans et sur la boîte...
  • Página 9: Raccordement De L'alimentation

    F r a n ç a i s GUIDE DÉTAILLÉ 1. Retirer les composants de l’appareil et l’emballage des pièces. S’assurer que toutes les pièces sont incluses. Note: Faites attention aux petites pièces et détruisez le matériel d’emballage car ils pourraient être dangereux pour les enfants. Couper l’électricité...

Tabla de contenido