Care And Cleaning; Troubleshooting - Defiant MSLED1801D Guia Del Usuario

Luz de resalte led solar activada por movimiento con giro de 180
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

care and cleaning

Proper care should ensure the longest possible life for your battery.
Make sure that your solar panel is located in a sunny location.
When battery is low, the fixture will flash twice to indicate it will automatically turn OFF and the red LED
indicator light will blink every 5 seconds at night. When battery is at minimum required charge or higher,
the red LED indicator light will be off. The fixture will not turn ON until the battery has recharged to the
operating level.
To ensure proper recharge, turn fixture OFF and allow fixture to receive 4 full days of sunlight before
turning the fixture ON.
It will be necessary to periodically clean the solar panel with soft wet cloth.

troubleshooting

Problem
Light does not
come ON with
motion at night.
Light stays ON at
night and does
not turn OFF.
Light is ON
during the day.
Possible Cause
Surrounding external ambient
light is too bright. (If so, the
unit may think it is daytime.)
Fixture is not charging during
the day.
There is motion in the
detection zone.
The switch on the bottom of
the motion sensor is in the
TEST mode.
The motion detector is
shadowed.
Re-aim the head.
Relocate or reposition the unit away from
the light.
Solar panel must be connected to the connector
extending from the side of the fixture housing
when charging.
Solar panel must be receiving direct sunlight to
charge during day (reposition if shadowed).
Solar panel must be clean and free from debris.
Make sure batteries have been charged for 4 full
days of sunlight prior to turning the fixure ON.
When battery is low, the fixture will blink twice
and automatically turn OFF until the battery is
charged to the operating level.
Make sure the sensor is not picking up moving
objects such as trees, traffic, etc.
Reposition motion sensor.
□ If the light continues to stay on, contact
Customer Service.
Move the switch to 1 min. or 3 min.
Reposition motion sensor.
8
Solution

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido