Display - Kenmore 580.72056 Manual Del Propietário

DISPLAY
REMOTE CONTROL SIGNAL RECEIVER
TEMPERATURE SETTING
• Use this button to automatically control the temperature
of the room. The temperature can be set within a range of
60°F to 86°F by increments of I°F,
I ,_ _ ENERGY SAVER
V TEMP J_. oThe fanstops when t hecompressor stops c ooling.
Approximately every 3 minutes the fan will turn on and
-- -- check the room air to determine if cooling is needed.
r
_. SAVER
o I /- DISPLAY COOL/FAN
-- -- I | ° Everytime you push this button, it will toggle between
MODE COOLO R
• You will usually use shut-off time while you sleep.
I • If unit is running,Timer sets numberof hours untilshut-off.
• Foryour sleeping comfort,onceTimer is set, the Temperature
TIMER O
setting willraise 2°F after 30 min.,and once again after another
L ON/OFF 30 min.
• Everytime you pushTimer button,it advancesthe Timersetting
as follows: 1 Hour _,2 Hours _.etc. m, 1 2 Hours maximum.
I FAN "_
SPEED|
/LOj
START TIME
• If unitisoff, Timer sets numberof hoursbeforeunit starts.
• EverytimeyoupushTimerbutton,itadvances theTimersetting
as follows: 1 Hour _.2 Hours_.etc. t, 12 Hours maximum.
POWER
• To turn the air conditioner ON, push the button. To turn the air
conditioner OFF, push the button again.
• This button takes priority over any other button.
• When you first turn it on, the unit is in cool mode, High fan
speed, Temperature setting at 72°F.
FAN SPEED
• Ever/time you pushthis button,it advancesthe settingas
follows: {High(F2) _. Low(F1) _ High(F2)}
-10-