DISPLAY
POWER
• To turn the air conditioner
ON, push this button. To
turn the air conditioner OFF, push the button again.
• This button takes priority over any other buttons.
• When you first turn it on, the unit is in cool mode,
High fan speed, Temperature
setting at 72'_F.
REMOTE CONTROL SIGNAL RECEIVER
1
MODE
- Every time you push this button, it will shift among
COOL, ENERGY SAVER and FAN.
- ENERGY SAVER
• The fan stops when the compressor
stops cooling.
Approximately
every 3 minutes the fan will turn on and
the unit will check the room air to determine if cooling is
needed.
FAN SPEED
• Every time you push this button, it advances the
setting as follows : {HIGH(F3) -* LOW(F1) -*
MED(F2)-*
HIGH(F3)}
TEMPERATURE SETTING ..........................................
• Use this button to automatically
controt the
temperature of the room. The temperature can be
set within a range of 60_'F to 86°F by increments
of
I°F.
Ir.,1_lCo; r_lrf.'f_,"
1
When power is restored after an
I
electrical power failure, the unit will begin
J
to run at its last setting.
AIR DIRECTION
ADJUSTMENT
HORIZONTAL
AIR DIRECTION CONTROL
The horizontal
air direction
is adjusted
by moving
the vertical
louvers
right and left with your
fingertips.
(FIG.
14)
TIMER
- SHUT-OFF
TIME
• You will
usually
use shut-off
time while you
sleep.
• With unit
running,
use Timer to set number of hours until
shut-off.
• For your
sleepingcomfort,
once Time is
set,
the
Temperaturesetting
will raise 2F after 30
min.,
and
2°F after another 30 min.
•
Every
time you
pushTimer button,
it advances
the Timer
setting
as follows:
1
Hour
-, 2
Hours
-*
etc.
-* 12 Hours
maximum.
- START TIME
• With unit not running,
use Timer to set number
of hours
before unit starts.
• Every time you push Timer button,
it advances
the Timer
settingas follows: 1 Hour-* 2 Hours -* etc. -* 12 Hours
maximum.
VERTICAL
AIR DIRECTION
CONTROL
The vertical
air direction
is adjusted
by moving
the
horizontal
louvers
up and down with your fingertips.
(FIG. 15)
FIG. 14
FIG.
15
-11-