Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTION! Damage may occur to painted surface if chemical is
allowed to dry on surface. Wash and rinse a small section at a
time. Avoid working on hot surfaces or in direct sunlight.
SHUTTING DOWN AND CLEANING
(If you're not using detergent go straight to step number 2). Once you finish using
01
the detergent on the surface, fill the detergent dispenser with clean water. Keep
water running at low pressure for one minute, so the water will come out from the
compartment.
02
Unplug the Washer directing the switch to "0" position.
Unplug the power cord from the mains.
03
04
Turn off the tap.
Press the gun trigger to empty the water.
05
Disconnect the hose that supplies water to the washer.
06
Pull the trigger safety lock.
07
CAUTION! Damage may occur if you do not empty the washer.
If taking a break of five minutes or more:
Engage gun safety lock.
01
Unplug the power cord from the outlet.
02
Turn unit to off ("0" position).
03
CAUTION! Failure to clean properly will cause the detergent
injection system to become clogged and inoperable.
• Bleach, chlorine products and other corrosive chemicals
• Liquids containing solvents (i.e., paint thinners, gasoline, oils)
These chemicals will harm the unit and will damage the surface being cleaned.
TAKING A BREAK
CAUTION! Never use:
• Tri-sodium phosphate products
• Ammonia products
• Acid-based products
37
Publicidad
Tabla de contenido
