Bose Professional ControlSpace WP22B-D Guia De Instalacion página 14

WP22B-D Installation Guide
pro.Bose.com
Mounting
A typical installation will involve mounting the wall plate into a 2-gang
junction box or low-voltage ring. Before starting, make sure the wall
box where the WP22B-D is to be installed is pre-wired with a suitable
network cable back to a PoE enabled network switch or mid-span
injector. If a mid-span injector is being used, the cable should be
connected to the port that supplies both Ethernet and power (refer to
the devices manual if unsure which port is which).
Attach the network cable from the switch/mid-span injector to the
Dante network port of the Dante WP22B-D. If the switch or mid-span
injector is already running and PoE is enabled, the unit should power
up and the green ID LED on the front of the device should turn on.
With the cable attached, place the WP22B-D into the wall box taking
care to not trap the cabling. Once in place, secure it with the mounting
screws provided. Finally, fasten the Decora plate on top using the
screws provided with it.
14