Operating Instructions - Hammerhead HCCH120 Manual Del Usuario

oPERATInG InsTRUCTIons

1. How To Charge
noTICE: The integrated battery is shipped
partially charged. Before using it the
first time, fully charge the battery. A fully
discharged battery will normally charge
in about 2 hours in a surrounding
temperature between 32°F (0°C) and
131°F (55°C)
a. Charge the tool only with the
correct charger.
b. Lock the variable-speed trigger
switch on the tool by placing the
direction-of-rotation selector in the
center position.
c. Align the slots of the integrated
battery with the electrical contacts
of the charger, and then slide the
tool into the charger.
d. Connect the charger to the power
supply. The charger can be only
used with normal household volt-
age of 120 volt AC, 60 Hz.
e. The red and green charging
indicator lights will illuminate for
approximately one second and then turn off. The charger will communicate with the
tool to evaluate the condition of the battery.
f. The green light will flash while the battery is charging normally. When charging is
complete, the green indicator light on the charger will illuminate.
g. A flickering red light indicates a defective battery or a bad connection between the
battery and the charger.
noTICE: For your convenience, the charger can operate with most generators and inverters
rated at 13 watts or higher.
8
1
CHARGER FOR COMPACT IMPACT DRIVER/AUTO HAMMER