Fan Assembly. Pgs - Craftmade Ellington RVF52ABZ5 Guia De Instalacion

5. Fan Assembly.
If you wish to extend the hanging length of your fan,
you must remove the hanging ball from the 6-inch
downrod provided to use with an extended
downrod (sold separately). [If you wish to use the
6-inch downrod, please proceed to instructions
following the first dotted line below.]
To remove hanging ball, loosen set screw on hanging
ball and remove pin and clip. Lower hanging ball
and remove stop pin. Slide hanging ball off the
original downrod, A, and slide it down the longer
downrod, B (the top of the downrod should be noted
as having a set screw hole; use this hole when setting
the set screw). Insert stop pin into top of extended
downrod and raise hanging ball. Be sure stop pin
aligns with slots on the inside of the hanging ball.
Tighten set screw securely. [Refer to diagram 1.]
Remove vice from safety cable by loosening the
screw and nut on the vice. [Refer to diagram 2.]
Tip: To prepare for threading electrical wires through
downrod, apply a small piece of electrical tape to the
ends of the electrical wires--this will keep the wires
together when threading them through the
downrod.
Loosen yoke set screws and nut at top of motor
housing. Remove pin and clip from downrod (if you
have not already done so). Slide downrod through
canopy and weatherproof yoke cover.
Thread safety cable and electrical wires through
downrod and pull extra wire slack from the upper
end of the downrod. [Refer to diagram 3.]
Thread downrod into the motor housing yoke until
holes for pin and clip in downrod align with holes in
yoke--make sure wires do not get twisted. Re-insert pin
and clip that were previously removed. Tighten yoke
set screws and nuts securely. [Refer to diagram 3.]
Lower weatherproof yoke cover to motor housing.
Remove electrical tape from electrical wiring and
thread one wire through each hole in the
weatherproof hanging ball cover. Pull weatherproof
hanging ball cover down securely over hanging ball
(on downrod).
["Fan Assembly" continued on next page.]
NOTE: The important safety precautions and
instructions appearing in the manual are not meant to
cover all possible conditions and situations that may
occur. It must be understood that common sense and
caution are necessary factors in the installation and
operation of this fan.
set screw
clip
A
diagram 1
safety cable
diagram 2
weatherproof
hanging ball cover
electrical wiring
hanging
ball
clip
diagram 3
page 4
set screw hole
stop pin
hanging ball
pin
B
nut
vice
screw
safety cable
downrod
canopy
weatherproof
yoke cover
yoke set screw
pin
motor
housing