Last Function Memory; Initialization Of The Microprocessor - Denon TU-1500AE Instrucciones De Operación

6
TUNING/PRESET
Press the
• The cursor "__" starts flashing in the next place.
• Repeat steps 5 and 6 to input "E", "N", "O" and
"N", in that order.
(Up to 8 characters can be input.)
7
TUNING/PRESET
Press the
seconds or press the
preset channel "A2" flash.
• When "__" is flashing, preset channel "A2" can also
be made to flash by pressing the TUNING/PRESET
knob for at least 2 seconds or by pressing the
MEMORY button.
8
With channel "A2" flashing, press the
TUNING/PRESET
button.
The station name you have input is stored in the
memory.
This procedure can be used to registered station
names with up to 8 digits for up to 100 AM/FM
stations at random.
The 63 characters below can be selected.
Overwrite a "_" (Space) to erase an inputted character.
A B C D E F G H I J K L M N O P Q R S T U V W
X Y Z 0 1 2 3 4 5 6 7 8 9 [ \ ] ^ _ ! # " $ % & ' ( )
+ , – . / : ; < = > ? (space)
knob to set "D".
knob for at least 2
MEMORY
button to make
MEMORY
knob or the
*

Last function memory

• The next time the power is set to the "on" mode, the TU-
1500AE is set to the same status (band, frequency, preset
channel number, mode setting, etc.) as when the power was
last set to the "standby" mode.
• The unit is also equipped with a back-up memory. This
function provides memory storage when the power switch
is off and with the power supply cord disconnected.

Initialization of the microprocessor

If the display or operation is abnormal, use the procedure
described below to reset the microprocessor.
1
ON/STANDBY
Press the
set the power to the "standby" mode, then
unplug the TU-1500AE's power supply cord
from the power outlet.
2
While pressing both the
buttons, plug the TU-1500AE's power supply
cord into a power outlet.
3
Check that the entire display is flashing with
an interval of about 1 second, and release your
fingers from the 2 buttons.
• The microprocessor will be initialized.
• If step 3 does not work, start over from step 1.
• When the microprocessor is reset, all the settings are
restored to the factory default values.
16
ENGLISH
ENGLISH
Operation
POWER
or button to
DIMMER BAND
and