Publicidad
Idiomas disponibles
Idiomas disponibles
Fig. 5.
Anti – Sway
block on
front tire.
8. Next, rotate the Anti-Sway block so that it rests against the bike's seat tube (this is the frame tube into
which the seat post fits). See Fig. 6. Pull the strap across the bike's seat tube in a similar snug, but not over-
Sway b
tight motion as with the previous straps, and snap on to appropriate "nub." On some bikes, it may be
necessary to unbolt the Anti-Sway block and turn it around, and mount it to a tire (see Fig. 5.), or other
appropriate part of the bike. For very small bikes (children's and some ladies bikes) it may be necessary to
remove the Anti-Sway block. One of the advantages of the Hollywood Anti-Sway block, is that it's so
versatile, easy to use and easily removable.
9. Once all the bikes are mounted on the Baja Rack, and all the rubber straps are pulled snug (but not over-
stretched!) over their respective "nubs," use the 86" nylon-webbing strap around all the bikes (may be
necessary to go through the wheels), and the rear frame of the rack itself. Remember to re-check all straps
after the bicycles have been mounted. Re-tighten straps as necessary.
Fig. 7: On a bike with a slanted top tube, place top
tube on rear cradle, and down tube on front cradle
to keep bike as "level" as possible.
Esta hoja de instrucción es aplicable para, 2 y 3 bicicletas capacidades en esta porta bicicletas por favor
seguir las siguientes importantes recomendaciones:
•SE instala el portabicis Baja en cubiertas metalicas solamente.Si posees una mini furgoneta o un vehículo para uso (SUV), estar
seguro leer las notas especiales abajo.
.Nunca poner los ganchos al aluminio, plástico, cristal, fibra de vidrio, carbón. Si duda, comprobar la superficie con un imán. Si
pega, es aceptable utilizar el portabici. Si no, no utilizar el portabici en el vehículo. Los ganchos de la correa del portabici pueden
dañar la superficies . Los ganchos se pueden unir a las barras cruzadas de la azotea. Comprobar el contorno de la barra primero. Para
estar seguro que aceptara y conservara el gancho con seguridad .
• Limpia la superficie de la puerta posterior o de la tapa de la cubierta antes de la instalación del portabici. Limpiar las superficies de
las esponja en tu portabici Baja. La suciedad atrapada entre los cojines del portabici y el maletero puede rasguñar la pintura del
vehículo debido a la composición abrasiva de la suciedad.
• Aprieta las seis correas todas antes y después que montan las bicis en el portabici.
• Nunca pone más de 35 libras por Bicicletas en el Baja 2 o Baja 3 . No Bicicletas Electricas.
If you have any questions or installation problems,
please see your local retailer or call Hollywood
Engineering at 800-747-4085 Mon.-Fri.
from 7:00AM–3:00PM Pacific time.
Euro Note: Special instructions for use in Europe: It is the
driver's responsibility to insure that the vehicle number plate
and lights are visible.
Special Notes for SUV's and Mini-Vans: The rear cargo
door on many SUV's and Mini-vans may not be structurally
strong enough to support the weight of the Baja rack and
bicycles. For these vehicles we recommend the Model F4
Heavy Duty, or F6 Expedition bumper mount racks. If your
vehicle has a 1-1/4" or 2" receiver hitch, we recommend
fitting a Hollywood hitch rack.
Hollywood Baja 2 y 3 Portabicicletas
Fig. 6 Anti-Sway
block on seat tube.
3
Publicidad
