Printronix SL4M Guía De Referencia Rápida página 7

Load Ribbon
For direct thermal media (no ribbon required), go to page 10.
Media Cover
IMPORTANT
Clean the printhead, platen roller, and media sensors every
time you change the ribbon. Refer to the User's Manual.
1. Raise the media cover.
2. Install the ribbon take-up core on the ribbon take-up spindle.
NOTE: The first ribbon take-up core comes with the printer.
3. Slide the ribbon roll onto the ribbon supply spindle until it is
flush with the flange.
4. Open the pivoting deck by rotating the deck lock lever fully
counterclockwise until the deck swings upward.
Pivoting
Deck
Thereafter, move the empty core from the ribbon supply
spindle to the take-up spindle after the ribbon is used up.
Load Ribbon
Flange
Ribbon
Take-Up Core
Ribbon
Take-Up Spindle
Ribbon
Roll
Ribbon
Supply Spindle
Deck Lock
Lever
1
7