Start Up; Rotation Direction - PRETUL ROTO-3/8P6 Manual De Instrucciones

Start Up

Bit fitting
• Put the bit into the chuck until it stops. Fasten with the
chuck wrench and tighten alternately the chuck into
each of the orifices.
WARNING
Clean the burrs and any other foreign
objects of the drill and the broker, otherwise the drill
cannot get tight and cuse serious personal injury.
Turn on and operation control
• Intermittent operation:
Connect the plug into the power inlet.
Press the switch (A) to start the hammer drill.
To stop, just release the switch.
• Continuous Operation:
Connect the plug into the power inlet.
Press the switch (A) and block it pressing the continuous use button (B).
To stop, press and then, release the switch.
Speed control
• The tool can run in different speeds. Select by adjusting speed control (C) in the
switch.
• Turn speed control clockwise to increase the hammer drill speed and torsion.
• Turn counterclockwise to lessen speed and torsion.
Changing from hammer drill to drill
• To drill concrete, floor tile or materials of similar hardness, move the impact-rotation
selector (D) completely into the IMPACT (
and rotate onto the material.
• To drill metal, wood or plastic, move the impact-rotation selector completely into the
ROTATION ( ) position. The bit will rotate onto the material.
WARNING Do not try to drill metal; wood or plastic with the hammer drill into
IMPACT ( ) mode setting. Otherwise the tool efficiency will lessen and the bit tip would
get damaged.

Rotation direction

• To get the bit to rotate forward and drill, move the rotation selector lever (E)
towards the arrow pointing the chuck.
• To get the bit go reverse and use the tool as a screwdriver, move the rotation
selector lever towards the arrow pointing the hammer drill handle.
WARNING
Never use the tool in reverse when the impact-rotation selector is
in the IMPACT ( ) position, otherwise, the impact system will be severely
damaged.
Bit
) position. The bit will simultaneously impact
Chuck
B
C
A
D
Rotation selector lever
in the drilling position
E
Switch
ENGLISH
Chuck
wrench
7