Moen INS207 Instrucciones De Instalación

Rotating Holder
Handheld wall bracket may be installed in
either righthanded or lefthanded position
by simply rotating the holder 180°.
CAUTION: NOT TO BE USED AS A
GRAB BAR.
A
(Part A is only provided
in C/P models)
3. Line up part A and part B with the holes drilled into the wall. Screw in
parts A and B with the screws provided. Snap part C on last.
Moen products have been manufactured under the highest standards of quality and workmanship. Moen warrants to the original consumer purchaser all
parts of this product to be free from defects in material and workmanship during normal use, for (1) year from date of purchase. A replacement for any defective
part will be supplied free of charge for installation by you. Defects or damage caused by the use of other than genuine Moen parts are not covered by this
warranty. This warranty shall be effective from the date of purchase as shown on the purchaser's receipt. Some states do not allow limitations on how long an
implied warranty lasts, so the above limitation may not apply to you.
This warranty is valid for the original purchaser only and excludes product damage due to installation error, product abuse, or product misuse, whether
performed by a contractor, service company, or yourself. Moen will not be responsible for labor charges, and/or damage incurred in installation, repair or
replacement, nor for incidental or consequential damages.
Some states, provinces, and nations do not allow the exclusion or limitation of incidental or consequential damages, so the above limitations or exclusions
may not apply to you. This warranty gives you specific legal rights and you may also have other rights which may vary from state to state, province to province,
and nation to nation.
Moen Incorporated will advise you of the procedure to follow in making warranty claims. Simply write to Moen explaining the defect and include proof of
purchase and your name, address and telephone number. The address is: Moen Incorporated, 25300 Al Moen Drive, North Olmsted, OH 44070-8022, or call
our toll-free consumer Helpline: 1-800-289-6636.
In Canada, write to Moen Inc., 2816 Bristol Circle, Oakville, Ontario L6H5S7 or call: Toronto, 905-829-3400; Rest of Canada, 1-800-465-6130, and ask for
Product Service.
®
1-5/16"
1. Drill two 1/4" diameter
holes, spaced 1-5/16" apart,
in the wall at the desired
bracket location (be sure
holes are drilled parallel to
the floor line).
B
C
ONE YEAR
LIMITED WARRANTY
25300 Al Moen Drive, North Olmsted, OH 44070-8022
HANDHELD WALL BRACKET
INSTALLATION INSTRUCTIONS
➤
2. Place the two plastic screw
anchors provided into the
holes and gently tap with a
hammer until flush with the
finished wall.
WARNING
Removal of the flow control o-ring
from the flow restrictor in the shower
wand between the wand and the
hose connection could cause the
wand to separate from the hose
assembly under use and may cause
a safety hazard.
®
®
INS207
Wall
Screw
Anchor
© Copyright, 1999
Moen Incorporated