Cleaning And Maintenance - Suncourt THRUWALL TW108 Instrucciones De Instalación

Step 3. Project the edge of the cutout onto the inside of the other wall board in three places, approximately 120° apart. Use a small square or a piece of
cardboard that has an exact 90° angle to mark the cutout points on the inside of the other wall. The two circular openings must be accurately aligned. (Refer
to picture 3)
Step 4. Use a small sharp pin or very small drill bit (1/32" or smaller) to punch or drill these three marks to the outside of the other wall. (Refer to picture 4)
Step 5. Place the other sleeve, with grille attached, against the outside of the wall and center its location using the three markers that you have made, then
trace the outside of the sleeve with a pencil. Cut the circular opening with a small drywall saw. Cut inside the pencil line. Take care not to damage the edge of
the drywall. You will be installing drywall anchors close to the hole to mount the grille. (Refer to picture 5)
Step 6. Insert the metal sleeve with grille into the cutout opening (fan output side) and snug the flange up against the wall material, making sure that power
cord is hanging straight down.
Step 7. Insert the other metal sleeve into the cutout opening (fan suction side) and snug the flange up against the wall material.
Step 8. Position the unattached plastic grille over the metal sleeve that was just inserted so that the Suncourt® logo is at the bottom and one of the mounting
holes is in the top center. Mark the location of all 3 wall anchors. Make sure that the grille ribs are nicely square with the floor.
Step 9. Mark the position for the wall anchors on the grille.
Step 10. Remove metal sleeve with grille attached and drill the holes on both sides of the wall for the anchors with a sharp 3/16" drill bit. Install wall anchors
and after re-inserting metal sleeve with grille attached, screw the grilles down snugly. DO NOT OVERTIGHTEN. (Refer to picture 6)
Pic. 1

CLEANING AND MAINTENANCE

Before cleaning the TW108 ThruWall Fan™ unplug or switch power off at the appropriate breaker. Dust may be removed from the exterior surfaces using a
soft cloth, the round brush attachment of your vacuum cleaner, or using a cloth that has been lightly moistened with water and a mild, non-abrasive
detergent.
ONE YEAR LIMITED WARRANTY
Subject to the following limitations, Suncourt® Inc. (manufacturer) warrants that the ThruWall Fan™ will, for 1 (one) year from date of original retail
purchase, but not exceeding 2 (two) years from date of manufacture, remain free from appearance of defects in workmanship or materials. This warranty is
subject to the following limitations: (a) manufacturer's liability is limited to the replacement or repair of the unit, as decided by the manufacturer; (b) a
defective unit must be returned, prepaid, with proof of purchase, well packaged to avoid damage in transit; and (c) this warranty does not apply to defects
resulting from the alteration, abuse, accidental damage, unauthorized repair, or misuse of the unit. This warranty is given in lieu of all other warranties,
guarantees, and conditions on manufacturer's part, and the manufacturer shall have no tortious or other liability in respect to this ThruWall Fan™. Ship unit
to Suncourt® Inc. only after obtaining a Return Goods Authorization (RGA) number. Returns without this RGA number will not be accepted.
Actual product appearance may differ from illustrations.
Suncourt® reserves the right to modify any or all of its products' features, designs, components and specifications without notice.
Pic. 2 Pic.3
Pic. 5
Pic. 4
Pic. 6
SUNCOURT® INC.
P.O. Box 40
Durant, IA 52747-0040
1.800.999.FANS (3267)
www.suncourt.com