STACK-ON TD-40-SB-B-S Instrucciones página 2

IMPORTANT:
Your safe is delivered with a Safety
Interlock Screw which must be
removed in order for you to lock your
safe. Failure to do so will
compromise the safety and security
of your safe.
First open the safe by turning the handle
clockwise and pulling the door open.
Locate the Safety Interlock Screw on the side of
the door; unscrew with a Phillips screwdriver,
remove and discard the screw.
Your safe can now be closed and locked.
Do not lock your instruction manual and/or keys
in the safe. You will need this manual for the
instructions on locking and unlocking the safe.
Safety Interlock Screw
BATTERY INSTALLATION
You must rst install the ba eries which are
located in the ont protective Styrofoam.
is safe uses 4 - AAA ba eries. Under normal
use, ba eries will last about 1 year.
NOTE: Do not mix old and new ba eries.
Do not mix alkaline, standard or rechargeable
ba eries.
NOTE: When changing or installing the
ba eries, do not pull on the wires. Doing this
could cause the power supply to become
disconnected from the lock.
NOTE: If the ba eries are low, the yellow light
will ash when you press the scanner.
To replace the ba eries, remove the lock faceplate
by pressing the tab and turning the cover as shown
in the illustration below.
TAB
2
20
40676-1605