STACK-ON TD-040-GP-E Manual Del Usuario

TD-040-GP-E
WARNING
A child or adult can tip the safe and
be killed or seriously injured.
Failure to secure the safe as shown in
these instructions can result in death
or serious injury to children and adults.
Children should not play with or
around the safe at any time.
Serial # :
Your Electronic Safe Combination #
Hardware Included:
(2) M10x70 Lag screws
(2) gasket washers
(2) plastic anchors
(12) plastic shelf clips
®
Instructions
Tip Over Hazard
Tools required:
drill
3/8 drill bit
5/16 drill bit
7/16 drill bit
17mm socket wrench
Phillips screwdriver.
IMPORTANT:
• Record the serial number from the tag on the
back of the safe or from the tag on the front
bottom corner of the safe.
• Keep keys and combination in a secure
place away from children.
• Do not store back up key or this document
in the safe.
• Do not move this safe using its handle. The
handle should only be used for opening and
closing the door of the safe.
• Warning: Keep your safe closed and
locked at all times when not in use. Children
could accidentally be locked inside the safe.
• NOTE: Stack-On is not responsible for any
cost incurred if the safe is replaced due to a
flood.
• Do not store electronic media, computer
disks, audio-visual media or photographic
negatives in this safe. This material will
not survive the rated internal temperature
of the safe. This material may be damaged
or destroyed.
HANDLE ASSEMBLY
Screw the 5 handle spokes into the hub and hand
tighten. ese spokes are located in the front foam
packaging.
NOTE: Do not use this handle to move the safe.
1
18
40708-1607