Battery Installation; Selecting Channels - Graco 2M17 El Manual Del Propietario

Parent Unit
• The battery must be plugged into the Parent
Unit before the unit will be ready for use.
Remove the battery door cover on the Parent
Unit with a key or flat blade screwdriver. Remove
the battery pack from the packaging and plug
into the back of the unit. Place the battery pack
into the recess and press the wire into the slot
on the side. Replace the battery door.
Nursery Unit
• Turn the unit over, and use Phillips screwdriver
to remove the battery door.
• Place 3-AAA (1.5V-LR03) batteries into the
battery compartment. Note the proper
orientation of the batteries.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon zinc), or
rechargeable (ni-cadmium, etc) batteries.
• Place the battery door back on the unit.
• Please remove a dead battery promptly.
A dead battery left in the unit may leak,
damaging your unit.
• Do not attempt to recharge a non-rechargeable
battery.
• A rechargeable battery CANNOT be recharged by plugging the AC adapter into the Nursery Unit.
• Remove the batteries from the unit if it is no longer being used or will be stored for an extended period
of time.
• The Parent Unit(s) can use either the rechargeable battery that comes with the unit or standard 120 volt
AC household current. The Nursery Unit uses 3-AAA (1.5V-LR03) batteries or standard 120 volt AC
household current.
• To use AC adapters, plug the connector on the cord into the AC adapter jack on the side of the Parent
Unit and the back of the Nursery Unit. Then plug adapter into a standard wall outlet.
• Use ONLY the Graco adapters included with the unit. Do not use these adapters with other equipment
under any circumstances.
• If units do not work, check that AC adapters are plugged into working outlets.
• When electricity is off (from a power failure, etc.), the Nursery Unit will operate on 3-AAA (1.5V-LR03)
batteries. If the Power LED is not lit, turn the power off and then back on to the Nursery Unit. A green
LED indicates that the batteries are fine. A red LED indicates that the batteries are low. If the LED does
not light at all, then replace the batteries. The Parent Unit will operate if the rechargeable battery is
charged.
• Remove and discard static cling labels.
• In case you are experiencing some interference, the channel on the Nursery Unit can
be changed by pressing the "ch" button on the front of the unit. The Parent Unit will
automatically scan all of the available channels until it locks on to the Nursery Unit.
If you are still experiencing interference, press the channel button on the front of the
Nursery Unit up to 6 times until a good channel is found.

Battery Installation

Using AC Adapters
Static Cling Labels

Selecting Channels

3
Plug in cord
Batteries should be disposed of properly
by recycling.