CAMBRIDGE MaytRx Guía De Referencia página 3

Tools Required For Kit Installation:
Safety Goggles
Ear Protection
Dust Mask
Gloves
Shovels (Digging & Flat)
Metal Cutters (For banding on cubes)
Mason Hammer (Chipping & Hammer)
Road Stone Rake
Tamper (Hand or Mechanical)
Wheelbarrow
Level (2' and 6' recommended)
Speed Square
Caulk Gun 10 oz or 28 oz (depends on what
size adhesive is purchased)
Rubber Mallet
14" Demo saw with diamond blade
Tape Measure
Marking Device (pencil, soap stone, etc)
Chalk Line
Hand Broom
Concrete Tools (Trowel/Floats)
Drill & 1/16" bit
5/16" Nut Driver
7 ¼" Circular saw with wood blade
4" Electric grinder
4" Diamond cup grinder
3 Carpenters clamps
Cambridge Pre-Packaged / Pre-Cut
MaytRx Wall Bar Module
2
Items Included in the Bar Module Kit:
1 – Reinforced concrete lintel 32"x 4"x 6"
3 – Plastic shim pack sheet for leveling lintels
or block as needed
1 – Cubes of Cambridge Maytrx Wall
2 - Pallet of Maytrx Wall cut stones
1 – Set of Appliances
1 – Granite Countertop
1 - Installation manual for Concrete Pad,
Maytrx Wall, Granite and Appliances
Material Required:
¾" clean stone (approx. 3/4 ton)
Concrete (approx. 16-80 lb bags)
Cambridge concrete adhesive (approx. 3-29 oz.
or 8-10.3 oz. tubes)
(4 pcs) 2" x 4" x 8' lumber
2 ½" wood screws
½" rebar (approx. 20')
Silicone for granite
2011