Programming The Stb-020 - Alcad STB-020 Manual

PROGRAMMING THE STB-020

Once the IPTV receiver has been installed, it must be configured.
All STB-020 leave the factory with IP address: 192.168.10.100. In order to avoid conflicts with other
IP addresses, it is necessary to perform an initial configuration in local mode. Subsequently, it will be
possible to have access to the IPTV receiver via the LAN network either to reprogram it or to check its
operation status.
TV
STB-020
TV
STB-020
ENG
Navegador de internet
Web browser
Navigateur Web
DEFAULT IP 192.168.10.100
TV
STB-020
Ethernet cable
CAT-5e / CAT 6
TV
STB-020
Ethernet cable
CAT-5e / CAT 6
SS-100
SS-110
ST-100
ST-110
SV-200
100 Mb (max 100 m) Floor distributor
CAT-5e / CAT-6
19" Rack
IGMP
1 Gb (max 100 m)
CAT-5e / CAT-6
100 Mb (max 100 m)
Floor distributor
CAT-5e / CAT-6
19" Rack
IGMP
1 Gb (max 100 m)
STB-020 Web Configuration Manual - XX
DVB-T
DVB-S2
DVB-S
19" Rack
Campus distributor
IGMP
F.O. 1GB (SX/LX multimode max 550 m)
(LX monomode max 5000 m)
19" Rack
IGMP
Building distributor
CAT-5e / CAT-6